00196457-05_UM_SX12DX12_SR706_EN.pdf - 第196页
3 Technical data and assemblies Us er Manual SIPLACE SX1/SX2/DX1/DX2 3.11 Component trolley for SIPLACE SX1/SX2 From software version SC.706.xx Version 06/2012 EN 196 3.1 1.8 T ape container 3.1 1.8.1 Description The tap…
User Manual SIPLACE SX1/SX2/DX1/DX2 3 Technical data and assemblies
From software version SC.706.xx Version 06/2012 EN 3.11 Component trolley for SIPLACE SX1/SX2
195
3.11.7 Mount for the additional reel for the changeover table
3
Fig. 3.11 - 8 Mount for the additional tape reel
(1) Mount for the additional tape reel, item no. 03075622-xx
(2) Mounting device for the support
X series feeder modules can process component tapes without problems if the lateral offset be-
tween the feeder module and the tape reel does not exceed 60 mm. If a predefined setup means
that the maximum permitted offset cannot be maintained, we recommend that you use the mount
for an additional tape reel (item 1). Simply insert the mount into the holder (item 2) and push it
until the offset is less than the maximum permitted value of 60 mm. The component trolley has 5
holders in total. Each tape reel mount can hold 2 tape reels, which means that up to ten 15" (381
mm) tape reels can be positioned above the tape container.
max. 60 mm
(1)
(2)
3 Technical data and assemblies User Manual SIPLACE SX1/SX2/DX1/DX2
3.11 Component trolley for SIPLACE SX1/SX2 From software version SC.706.xx Version 06/2012 EN
196
3.11.8 Tape container
3.11.8.1 Description
The tape container can hold tape reels up to 19" (483 mm) in diameter. The insertion of separating
plates is described in section 5.9.5
page 276.
3
Fig. 3.11 - 9 Component trolley, SIPLACE SX1/SX2, with tape container
(1) Tape container with separating plates
(2) Waste tape container
(1)
(2)
User Manual SIPLACE SX1/SX2/DX1/DX2 3 Technical data and assemblies
From software version SC.706.xx Version 06/2012 EN 3.11 Component trolley for SIPLACE SX1/SX2
197
3.11.8.2 Maximum tape reel diameter in relation to the PCB conveyor height
3
PLEASE NOTE: 3
SIPLACE SX1/SX2 component trolleys do not generally need spindles. However, if the "Timeout"
error message occurs increasingly on the X feeder module, we recommend that you do use spin-
dles.
3.11.9 Used tape chute
3
Fig. 3.11 - 10 Used tape chute for the component trolley docking unit
PLEASE NOTE 3
The used tape chute for the SIPLACE SX1/SX2 can only be installed on the component trolley
docking unit
for the SIPLACE SX1/SX2 (see fig. 5.15 - 4, page 300).
Without mount for the
additional tape reel
With mount for the
additional tape reel
PCB conveyor
height
of the component
trolley
Tape reel diameter Tape reel diameter
without spindle with spindle
900 mm 19" 17" 15"
930 mm 19" 19" 17"
950 mm 19" 19" 19"