00196457-05_UM_SX12DX12_SR706_EN.pdf - 第229页
User Manual SIPLACE SX1/SX2/DX1/DX2 4 Setting up and commissioning From software version SC.706.xx V ersion 06/2012 EN 4.3 Setting up the machine 229 4.3.7.3 Machine foot clearances fo r the machine and WPC5 /WPC6 4 Fig.…
4 Setting up and commissioning User Manual SIPLACE SX1/SX2/DX1/DX2
4.3 Setting up the machine From software version SC.706.xx Version 06/2012 EN
228
4.3.7.2 Machine foot clearances for the PCB dual conveyor
4
Fig. 4.3 - 6 Machine foot clearances for the PCB dual conveyor in millimeters
Fixed conveyor side at maxi-
mum right position
a
.
Fixed conveyor side at
maximum left position
a
.
a) The value depends on the position of the fixed side.
All dimensions in millimeters.
User Manual SIPLACE SX1/SX2/DX1/DX2 4 Setting up and commissioning
From software version SC.706.xx Version 06/2012 EN 4.3 Setting up the machine
229
4.3.7.3 Machine foot clearances for the machine and WPC5/WPC6
4
Fig. 4.3 - 7 Machine foot clearances for the machine and WPC5/WPC6 in millimeters
a) Fixed conveyor side at maximum right position. The value depends on
the position of the fixed side. All dimensions in millimeters.
4 Setting up and commissioning User Manual SIPLACE SX1/SX2/DX1/DX2
4.3 Setting up the machine From software version SC.706.xx Version 06/2012 EN
230
4.3.8 Integrating the machine into the line
Observe the general warnings in section 4.3.1, page 218.
Observe the warnings for transportation of the machine in section 4.3.2, page 219.
For details of tools and equipment, refer to section 4.3.5, page 222.
4.3.8.1 Aligning and adjusting the machines in the line
With the fork-lift, raise the machine until the weight is taken off the machine feet.
Determine the PCB conveyor height for the machine in the line and use the hexagon socket
head screw to adjust the height approximately.
You may need to fit the machine feet to the relevant PCB conveyor height (see 4.3.6 on page
223).
Position the machine on the free location on the line using the fork-lift.
Pay attention to the alignment of the PCB conveyors and check the distance to the previous
machine.
WARNING 4
Lower the machine slowly. A second person should look underneath to ensure that all the
machine foot touch the floor at the same time. If the machine feet on one side hit the ground
hard, the fixings may be damaged.
4
Use the machine spirit level to align the machine in the X and Y directions (see 4.3.9 on page
231).
Align the PCB conveyors with the help of the long auxiliary board. Move the machine to its
final position. You must be able to push the long auxiliary board through the PCB conveyor to
the adjacent machine with ease and without jamming.
Use the machine spirit level to check the X and Y directions again and adjust the height of the
feet if necessary.
Tighten the machine feet at the clamping screw to a torque of 130 Nm.
Hit the feet with a hammer to check the load-bearing strength of the machine feet.
Use the machine spirit level to check the X and Y directions again.