00196457-05_UM_SX12DX12_SR706_EN.pdf - 第300页
5 Working with the machine User Manual SIPLACE SX1/SX2/DX1/DX2 5.15 Docking the component trolley in or out From software version SC.706.xx Version 06/2012 EN 300 5.15.4 Docking the component trolley 5 Fig. 5.15 - 4 Dock…
User Manual SIPLACE SX1/SX2/DX1/DX2 5 Working with the machine
From software version SC.706.xx Version 06/2012 EN 5.15 Docking the component trolley in or out
299
5
Fig. 5.15 - 3 Component trolley - swivel handles up to push
With both hands on the handles, pull the component trolley out of the machine.
5.15.3 Safety instructions for moving the component trolley
WARNING
To prevent accidents, ALWAYS follow the rules listed below when you move the component trol-
ley.
Always hold the handles with both hands when you want to move the component trolley.
Remember that a component trolley with the full complement of feeder modules can tip over
sideways or forward on gradients of 20° or more.
Make sure that the surface on which the trolley is moved has a significantly smaller gradient.
The floor underneath the machine may not exceed an incline of 0.63%. This corresponds to
an incline of 5 mm over a distance of 800 mm (e.g. the width of a changeover table).
Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast
enough.
5 Working with the machine User Manual SIPLACE SX1/SX2/DX1/DX2
5.15 Docking the component trolley in or out From software version SC.706.xx Version 06/2012 EN
300
5.15.4 Docking the component trolley
5
Fig. 5.15 - 4 Docking the component trolley
(1) Locking latches
(2) Height setting for fine adjustment to the machine height
CAUTION 5
Be careful when you push the component trolley for the SIPLACE X series
into the machine and make sure that the locking latches do not bump into obstacles.
(2)
(1)
User Manual SIPLACE SX1/SX2/DX1/DX2 5 Working with the machine
From software version SC.706.xx Version 06/2012 EN 5.15 Docking the component trolley in or out
301
PLEASE NOTE 5
Cut the component tapes off flush with the front end of the X feeder modules before you dock in
the component trolley, otherwise the empty tapes will not get into the empty tape duct.
CAUTION 5
Check that the placement head is outside the range of the component trolley.
Carefully push the component trolley into machine as far as the stop. The stop block (2) of
the changeover table must fit under the bracket for the table height check (1) on the machine
feed-in (right and left side).
5
Fig. 5.15 - 5 Table height check
CAUTION
Do not remove the two brackets (on the right and left side) for the table height check (1). If either
of these brackets is removed, the changeover tables could be too high, thus causing a head
crash. 5
5
(1)
(2)