00196457-05_UM_SX12DX12_SR706_EN.pdf - 第271页
User Manual SIPLACE SX1/SX2/DX1/DX2 5 Working with the machine From software version SC.706.xx V ersion 06/2012 EN 5.8 Changing shift 271 5.8.2 Safety instructions for em ptying the waste tape cont ainer 5 Fig. 5.8 - 1 S…
5 Working with the machine User Manual SIPLACE SX1/SX2/DX1/DX2
5.8 Changing shift From software version SC.706.xx Version 06/2012 EN
270
5.8 Changing shift
5.8.1 Activities at shift change
Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift
starts. This minimizes extended down times.
At the shift change, pass important information on to the next operator. This includes, for in-
stance, changes to the placement program. Also read through the list of the descriptions of
the steps to take in section 5.12
, page 293.
Carry out a setup check.
Make sure that the feeder modules are equipped with the correct components, that they are
at the correct locations on the component trolley/DX tables/DX changeover tables and that
the conveyor increment is set correctly.
Clean the following line assemblies:
Empty the reject bin and carefully vacuum the area around the reject bin.
Carefully vacuum the nozzle changers, feeder modules and the component trolley/DX tables/
DX changeover tables.
Empty the waste tape container. Follow the safety instructions given in section 5.8.2, page
271
.
User Manual SIPLACE SX1/SX2/DX1/DX2 5 Working with the machine
From software version SC.706.xx Version 06/2012 EN 5.8 Changing shift
271
5.8.2 Safety instructions for emptying the waste tape container
5
Fig. 5.8 - 1 Safety instructions for emptying the waste tape container
(1) Handle
(2) Waste tape container
The waste tape container must be pulled out of the component trolley for emptying. There is a risk
of catching your fingers as you do so.
To avoid this risk, hold the waste tape container with your fingers in the handle
(item 1).
Do NOT put your fingers in the gap between the tape container and waste tape container as
you could catch your fingers if you do.
(1)
(2)
5 Working with the machine User Manual SIPLACE SX1/SX2/DX1/DX2
5.9 Carrying out a sight check From software version SC.706.xx Version 06/2012 EN
272
5.9 Carrying out a sight check
The following chapter shows diagrams of the SIPLACE SX1/SX2. However, inspection of the X
feeder modules on the SIPLACE SX1/SX2 changeover tables is basically identical to inspection
of the DX tables/DX changeover tables in the SIPLACE DX1/DX2.
5.9.1 Checking the X feeder modules
5
Fig. 5.9 - 1 Checking the X feeder modules
(1) Flap
(2) Blade
(3) Status display
(4) LCD display
5