CP45-英文版培训教材.pdf - 第116页
Operating Manual Reference Figure CP-45/55 Operation Process ^ <Nozzle> Area/<Available> List Box This is to assign the nozzle to arrange in pocket on Optimizer. If executing the Optimizer in case as shown in…
Operating Manual Reference Figure
CP-45/55 Operation Process
^<Nozzle> Area/<Arranged>
List Box
An user can directly arrange
the nozzle on ANC pocket in
ANC Setup Dialogue. The
nozzles arranged already as
like this will be shown in
<Arranged> List Box as much
as the numbers arranged.
The nozzle listed in the box
can be used for the work,
however, can not be arranged
in the pocket optionally by
Optimizer. If you want to
re-arrange the nozzle arranged
already, select the desirable
nozzle, press the arrow button
(
) and then move it to the
<Available> List Box.
If an user want to directly
arrange again the nozzle,
pop-up the ANC Setup Dialogue
and assign the pocket.
Operating Manual Reference Figure
CP-45/55 Operation Process
^ <Nozzle> Area/<Available>
List Box
This is to assign the nozzle to
arrange in pocket on Optimizer.
If executing the Optimizer in
case as shown in Fig. A.3, one
TN14 nozzle and two TN22
nozzles will be arranged in the
empty nozzle pocket. Numbers of
nozzle to arrange by use of the
Optimizer can be increased or
decreased freely by clicking
the arrow buttons
and
between <Available> List Box
and the <Prohibited> List Box.
^ <Nozzle> Area/<Prohibited>
List Box
This List Box functions as the
a buffer for holding the
unnecessary nozzles. You may
put all of the unnecessary
nozzles in the <Prohibited> List
Box.
Operating Manual Reference Figure
CP-45/55 Operation Process
^ <Nozzle> Area/ <Nozzle #1 #2>
List Box
This List Box shows all nozzles
being used on PCB under edit,
and also displays the status
indicated with the 1st and the
2nd work nozzles of part for
individual nozzle.
#1and#2representthe1st
work nozzle and the sums of
the place origins of part
assigned with the 2nd work
nozzle respectively.
^ <Assign Nozzle> Button
This can be used for assigning
the head applicable to individual
nozzle. If pressing this button,
a Dialogue Box will be shown as
follows. Because all nozzle types
can be worked at any head
basically, that nozzle types were
checked in all heads. However,
in some cases, a certain nozzle
should be worked on a certain
head.