CP45-英文版培训教材.pdf - 第131页
Operating Manual Reference Figure CP-45/55 Operation Process to show individual assignment status optionally. Number shown in the right column means the repeat numbers of these cycles. #Component: The part assignment sta…
Operating Manual Reference Figure
CP-45/55 Operation Process
This area displays distribution
for concurrent pickup of part.
Since CP-45 has the total 6
heads, there are 6 types from
individual pickup to concurrent
pickup of 6 heads. Numbers
and ratio of the mounting points
worked by individual concurrent
pickup type will be shown in
this area.
#I : In case that only one head
picks the part(Individual
pickup)
#2S : In case that 2 heads pick
the part concurrently.
#3S : In case that 3 heads pick
the part concurrently.
#6S : In case that 6 heads pick
the part concurrently.
^ <Cycle> Area
This area displays part
assignment, feeder assignment,
and nozzle assignment status of
the final step program. 3 radio
buttons shown as follows enable
Operating Manual Reference Figure
CP-45/55 Operation Process
to show individual assignment
status optionally. Number shown
in the right column means the
repeat numbers of these cycles.
#Component: The part
assignment status is displayed
as c
x
for part to be worked by
individual head as c
x
,where
x
is
a number counted respectively
for part types.(in this case, not
displayed as a part name)
# Feeder: Feeder assignment
status is displayed with the
feeder lane to be picked-up by
individual head, the front feeder
base represents as F
x
and the
rear feeder base represents as
R
x
.Where
x
is a number of
feeder lane. Also, stick feeder
and tray feeder represent as S
x
and T
x
respectively. Where,
x
differs from a name of feeder
unit as a classification based
upon the pickup position.
Operating Manual Reference Figure
CP-45/55 Operation Process
#Nozzle: Nozzle assignment
status shows which nozzle uses
for certain nozzle. A name of
nozzletobeusedon
individual head will be displayed.