CP45-英文版培训教材.pdf - 第192页

Operating Manual Reference Figure CP-45/55 Operation Process 2.2.3 Non Stop Tape Feeder [F i g .2 . 2 . 2] -> Fixing method of 8 mm Non-Stop tape f eeder depends upon the types such as drain type, take up type, etc. F…

Operating Manual Reference Figure

CP-45/55 Operation Process

2.2.2 P-hydraulic Tape Feeder

(Drain-type Feeder )

->For 8mm drain type tape feeder,

Fix the upper cover tape by

putting the upper cover tape

between drain gear and forming

gear by turning the drain pole to

CW with taking up the upper of

drain gear, and then return again

the drain pole to CCW. At

this time, if the upper cover

tape(Vinyl) is too loosen, the

upper cover tape(vinyil) can not

be drained by the forming gear

and can be spread together with

the feed tape.

Drain Gear

Forming Gear

Drain Pole

Upper Cover

Tape

Roller C

Roller B

Roller A

Operating Manual Reference Figure

CP-45/55 Operation Process

2.2.3 Non Stop Tape Feeder

[Fig.2.2.2]

-> Fixing method of 8mm Non-Stop

tape feeder depends upon the

types such as drain type, take up

type, etc.

For drain type, put the upper cover

tape between idler gear and

forminggearbyhangitonRoller

A and B, passing it through the

slot B and placing it under

Roller D and above the Roller E.

At this time, Fix the upper cover

tape by pulling it tightly and

putting between two gears above.

Also care is to be taken for

ensuring that the upper cover tape

can be passed through evenly

without being folded or skipping

over rollers or gears when passing

through roller E or idler gear and

forming gear.

For take up type, apply the same

method as fixing method of the

existing take up tape feeder upper

cover tape. Refer to [Fig. 2.2.1].

Operating Manual Reference Figure

CP-45/55 Operation Process

Difference between The Existing

Feeder and Non Stop Tape

Feeder

3.1 Development Drawing

Drain-type Tape Feeder

Non Stop Tape Feeder