CP45-英文版培训教材.pdf - 第130页
Operating Manual Reference Figure CP-45/55 Operation Process This area displays distribution for concurrent pickup of part. Since CP-45 has the total 6 heads, there a re 6 types from individual pickup to concurrent picku…
Operating Manual Reference Figure
CP-45/55 Operation Process
^ <Placement> Area
This area displays quantity of
part types, quantity of total
mounting points, nozzle
replacement times and total
cycles. Since the total work time
above represents the estimated
time by a simulation, it may
differ from the actual mounting
time. When calculating the
outputs, produce one PCB from
the actual machine and refer to
the time.
^ <Arrangement> Area
This area displays the
arrangement status of Tape
Feeder and ANC nozzle. Pre
represents the quantity
arranged directly by an user,
New represents the quantity
arranged newly by Optimizer,
and Total represents the quantity
arranged totally.
^ <Pickup> Area
Operating Manual Reference Figure
CP-45/55 Operation Process
This area displays distribution
for concurrent pickup of part.
Since CP-45 has the total 6
heads, there are 6 types from
individual pickup to concurrent
pickup of 6 heads. Numbers
and ratio of the mounting points
worked by individual concurrent
pickup type will be shown in
this area.
#I : In case that only one head
picks the part(Individual
pickup)
#2S : In case that 2 heads pick
the part concurrently.
#3S : In case that 3 heads pick
the part concurrently.
#6S : In case that 6 heads pick
the part concurrently.
^ <Cycle> Area
This area displays part
assignment, feeder assignment,
and nozzle assignment status of
the final step program. 3 radio
buttons shown as follows enable
Operating Manual Reference Figure
CP-45/55 Operation Process
to show individual assignment
status optionally. Number shown
in the right column means the
repeat numbers of these cycles.
#Component: The part
assignment status is displayed
as c
x
for part to be worked by
individual head as c
x
,where
x
is
a number counted respectively
for part types.(in this case, not
displayed as a part name)
# Feeder: Feeder assignment
status is displayed with the
feeder lane to be picked-up by
individual head, the front feeder
base represents as F
x
and the
rear feeder base represents as
R
x
.Where
x
is a number of
feeder lane. Also, stick feeder
and tray feeder represent as S
x
and T
x
respectively. Where,
x
differs from a name of feeder
unit as a classification based
upon the pickup position.