FUJI NXT Programming Manual QD004-18.pdf - 第36页

3. Job Builder QD004-18 26 NXT Programming Manual 4. Repeat the previous steps until all of the desired nozzles for the positions have been set. 01PRG-0056E

QD004-18 3. Job Builder

NXT Programming Manual 25

Panel Stopping Position Correction

The new settings will take effect the next time the job is transmitted to the machine or

optimization is performed.

Specifying the head setup for an NXT

Making settings in the [Head Setup] tab is not normally necessary. The head setup will be

automatically reconfigured based upon the nozzles in the nozzle changer during

optimization.

1. There are several tabs at the bottom of the [Machine Configuration] pane. Select the

[Head Setup] tab.

2. Use the [Module] drop-down list to select the desired module to display.

3. Click the [Name] field in the nozzle table and then the arrow to display a drop-down list

of the available nozzles. Click to select the desired nozzle for that position.

Note: It is possible to specify nozzles for multiple positions at a time. Select the multiple nozzle

positions for the head and then right-click in the window. Select [Select Nozzles] and then

select the desired nozzle for the selected positions from the drop-down list and click [OK].

Setting Description

Scan Area X/Y This specifies the size of the area in the X- and Y-direction

checked for the panel edge when correcting the panel

stopping position.

Shutter Speed This setting specifies the shutter speed used by the mark

camera when checking for the panel edge. The larger the

value, the slower the shutter speed and the image

becomes brighter.

Color Specify which lighting should be used to check for the

panel edge. Different settings will be required depending

on the color of the panel.

Pattern Specify which lights should be used to check for the panel

edge. Different settings will be required depending on the

color of the panel.

3. Job Builder QD004-18

26 NXT Programming Manual

4. Repeat the previous steps until all of the desired nozzles for the positions have been set.

01PRG-0056E

QD004-18 3. Job Builder

NXT Programming Manual 27

Specifying the nozzle changer setup for an NXT

Making settings in the [Nozzle Changer Setup] tab is necessary if the nozzles in the

machine do not match the nozzles currently in this tab or if different nozzles are to be used

during production.

1. There are several tabs at the bottom of the [Machine Configuration] pane. Select the

[Nozzle Changer Setup] tab.

2. Use the [Module] drop-down list to select the desired module for which to set the

nozzles.

3. Click the [Name] field in the nozzle table and then the arrow to display a drop-down list

of the available nozzles. Click to select the desired nozzle for that position.

Note: It is possible to specify nozzles for multiple positions at a time. Select the multiple nozzle

positions for the changer and then right-click in the window. Select [Select Nozzles] and

then select the desired nozzle for the selected positions from the drop-down list and click

[OK].

4. Repeat the previous step until all of the desired nozzles for the positions on the nozzle

changer have been set.

01PRG-0057E