FUJI NXT Programming Manual QD004-18.pdf - 第72页

3. Job Builder QD004-18 62 NXT Programming Manual 3.4.9 Adjusting placement due to panel warp function (from NXT V5.15) This function improves pr oductivity by adju sting place ment based on the state of warpag e of the …

QD004-18 3. Job Builder

NXT Programming Manual 61

5. Set the following items.

Important points

• The dip switches on the feeder are disabled when the job is transmitted and the

settings in the job for tape pitch and indexing speed are used in production.

• The settings from the job are saved and remain even if the job is deleted. If the

feeder is removed from the pallet and then inserted again, the settings in the

feeder are cleared and the dip switches on the feeder are enabled.

• The dip switches on the feeder are enabled when the Package Data setting

[Assign Feeder Indexing Settings] is changed from [ON] to [OFF]. Use this

setting as required.

• When using AVL, tapes with different pitches or indexing speeds cannot be set.

• When splicing, tapes with different pitches or indexing speeds cannot be

connected.

• When using MEdit, the [Feed Pitch] is not used. It is only possible to set

[Indexing Speed] and the setting for using settings specified in the job [Assign

Feeder Indexing Settings].

• When performing different name dual production, do not specify different values

for [Assign Feeder Indexing Settings] for parts with the same device comment.

• With free allocation, when [Kit Line Configuration] - [Splicing Warning: ON] is

specified, set [Assign Feeder Indexing Settings] to [OFF].

• When the feeder firmware is not supported, guidance to exchange the feeder

displays. Change to a feeder that is supported.

Item Details

Feed Pitch The pitch of the tape (mm)

Indexing Speed The tape indexing speed

Assign Feeder Indexing Settings Set whether to specify the tape pitch

and indexing speed in the job (On/Off).

01PRG-0114E

3. Job Builder QD004-18

62 NXT Programming Manual

3.4.9 Adjusting placement due to panel warp function (from NXT

V5.15)

This function improves productivity by adjusting placement based on the state of warpage

of the panel. Throughput is improved by changing the speed change height of the placing

head for the previously fixed soft placement, simple pressure control, and Package-on-

Package placement.

Required items

Unit

A head supporting either soft placement, simple pressure control, or Package-on-Package

placement

Software

• NXT application (V5.15 or higher)

• Fuji Flexa (V5.0.0 or higher)

• MEdit (V5.15.0 or higher)

Soft placement Simple

pressure

control

Packgage-on-package

H01 Supported Supported Supported

H02 Supported Supported Supported

H04 Supported - -

G04 Supported Supported Supported

OF Supported - -

QD004-18 3. Job Builder

NXT Programming Manual 63

How to specify settings

Specify the value for the maximum panel warpage for a job with either soft placement,

simple pressure control, or Package-on-Package placement. This section explains two

methods for specifying the value, one in Fuji Flexa Job Builder and one in MEdit.

Specifying in Fuji Flexa Job Builder

1. Open the job in Fuji Flexa.

2. Select the [General] tab, on the job information bar in Job Builder.

3. Double click [Panel Information].

4. Enter the value for maximum panel warpage in the [Max. Panel Warpage] field of the

[Panel Information] dialog box.

• Setting range: 0.00 to 2.00 mm, default value: 0.00 mm (placement movement is not

changed)

01PRG-0116E