XP Type II 工程师培训手册 (2.0).pdf.pdf - 第184页
FK-9F98-34 XP T ype II Series T raining T ext for Service Engineers Edition 2.0 XP242E – Chapter 6 Proper Data Mea surement s Page 29 of 30 4. Adjust the position of the corner dog so that the two marks on the corner dog…
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP242E – Chapter 6 Proper Data Measurements Page 28 of 30
8. Set the conveyor width to minimum, then select [Manual Operation] – [Conveyor
Width] – [Measure Speed] – [START]. After the calibration is complete press [YES]
to save the results in proper data (ConvWidthMtrSpeed).
9. Once speed measurement is complete input a board width and select [Move] –
[START]. The conveyor automatically moves to this board width.
10. Select a board with the same width as that input in step 9 and place it in the
conveyor. The board should fit smoothly into the conveyor, and there should be a
clearance of 0.5mm between conveyor and board. If not it is necessary to measure
an offset.
11. Use the conveyor width changer inching tabs to change the conveyor width until the
clearance between board and conveyor is 0.5mm then select [Measure Offset].
After the calibration is complete press [YES] to save the results in proper data
(ConvWidthOffset).
6.20 Corner Dog
1. Select [Maintenance C] – [Proper Data Editor] – [MACHINE_TYPE] –
[CornerRearSide] – and set to “2”.
2. Select [Maintenance C] – [Custom Maintenance] – [Maintenance] – [Corner Dog
Adjustment] and the following screen displays:
3. Select [Acquire Image] – and hold down the [START] button until the image is
acquired.
Fuji Machine Mfg. Co., Ltd. Okazaki.
SMT Equipment Quality Assurance Dept.
6 – 28 CS Section
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP242E – Chapter 6 Proper Data Measurements Page 29 of 30
4. Adjust the position of the corner dog so that the two marks on the corner dog
bracket appear within the borders of the green search area as shown below:
5. Select [SIDE 2] – [Acquire Image] – and hold down [START] to confirm that the two
marks on the corner dog bracket appear within the borders of the green search
area at the side 2 camera.
6. After adjusting the position of the corner dog within the borders of the green search
area select [Vision Test] to confirm that the corner dog can be vision processed. If
vision processing is successful trace lines will appear on the corner dog as shown
in the photo below:
Fuji Machine Mfg. Co., Ltd. Okazaki.
SMT Equipment Quality Assurance Dept.
6 – 29 CS Section
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP242E – Chapter 6 Proper Data Measurements Page 30 of 30
NOTES:
Fuji Machine Mfg. Co., Ltd. Okazaki.
SMT Equipment Quality Assurance Dept.
6 – 30 CS Section