XP Type II 工程师培训手册 (2.0).pdf.pdf - 第19页
C C h h a a p p t t e e r r 2 2 O O r r i i g g i i n n S S e e t t t t i i n n g g s s
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP142E – Chapter 1 Initial Adjustment Page 8 of 8
Fuji Machine Mfg. Co., Ltd.Okazaki
5. Right-click in the group contents pane and select [New] – [Factory…]. The [New Factory]
dialog box displays.
6. Enter the factory name and click [OK]. The factory displays in both panes.
7. Select the factory, right-click in the group contents pane and select [New] – [Line…]. The
[New Line] dialog box displays.
8. Enter the line name and click [OK]. The line name displays under the factory.
9. Select the line, right-click in the group contents pane and select [New] – [Machine…]. The
[New Machine] dialog box displays.
10. Enter the machine details and click [OK].
11. Enter the PC host name in the [Machine Communication Server] field and then click [Save].
SMT Equipment Quality Assurance Dept.
1 – 8 CS Section
C
C
h
h
a
a
p
p
t
t
e
e
r
r
2
2
O
O
r
r
i
i
g
g
i
i
n
n
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP142E – Chapter 2 Origin settings Page 1 of 6
Fuji Machine Mfg. Co., Ltd. Okazaki
Chapter 2 – Origin Settings
2.1 Checking the X, Y, F and G Servo Parameters
1. Equipment: digital operator (JUSP-0P02A).
2. Press the emergency stop button to cut the 200-volt power supply to the servos.
3. Connect the digital operator to the relevant servo amplifier, (“bb” displays at the screen).
4. Press [DSPL/SET] to select the channel mode (Pn000).
5. Specify the number of the channel to be checked, then press [DATA/ENTER] to display.
6. Ensure that the values match those listed in the servo amp parameter list (the most
recent list at the time of publication can be found in the supplementary section of this
manual, however always check to see if the list has been updated).
7. When you have completed checking the parameters, return to the “bb” screen.
8. If any of the servo parameter values are changed, the machine must be rebooted before
continuing with adjustments.
9. If the “multiturn” limit parameter Pn205 is changed “A.CC” will display on the amp. In this
case connect a digital operator to the amp.
10. Press the M/C emergency stop button and then release it.
11. Press [DSPL/SET] and select channel Fn000.
12. Press the up key to select channel Fn013.
13. Press [DATA/ENTER] to display [PGSET].
14. Press [DSPL/SET] and (done) displays for one second.
15. Return to Fn000 and press [DSPL/SET] to return to the initial screen, which will still
display “A.CC” until the machine is rebooted.
16. Reboot the machine and confirm that “bb” or “run’ displays on the amp.
SMT Equipment Quality Assurance Dept.
2 – 1 CS Section