XP Type II 工程师培训手册 (2.0).pdf.pdf - 第20页
FK-9F98-34 XP T ype II Series T raining T ext for Service Engineers Edition 2.0 XP142E – Chapter 2 Origin settings Page 1 of 6 Fuji Machine Mfg. Co., Ltd. Okazaki Chapter 2 – Origin Settings 2.1 Checking the X, Y , F and…
C
C
h
h
a
a
p
p
t
t
e
e
r
r
2
2
O
O
r
r
i
i
g
g
i
i
n
n
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP142E – Chapter 2 Origin settings Page 1 of 6
Fuji Machine Mfg. Co., Ltd. Okazaki
Chapter 2 – Origin Settings
2.1 Checking the X, Y, F and G Servo Parameters
1. Equipment: digital operator (JUSP-0P02A).
2. Press the emergency stop button to cut the 200-volt power supply to the servos.
3. Connect the digital operator to the relevant servo amplifier, (“bb” displays at the screen).
4. Press [DSPL/SET] to select the channel mode (Pn000).
5. Specify the number of the channel to be checked, then press [DATA/ENTER] to display.
6. Ensure that the values match those listed in the servo amp parameter list (the most
recent list at the time of publication can be found in the supplementary section of this
manual, however always check to see if the list has been updated).
7. When you have completed checking the parameters, return to the “bb” screen.
8. If any of the servo parameter values are changed, the machine must be rebooted before
continuing with adjustments.
9. If the “multiturn” limit parameter Pn205 is changed “A.CC” will display on the amp. In this
case connect a digital operator to the amp.
10. Press the M/C emergency stop button and then release it.
11. Press [DSPL/SET] and select channel Fn000.
12. Press the up key to select channel Fn013.
13. Press [DATA/ENTER] to display [PGSET].
14. Press [DSPL/SET] and (done) displays for one second.
15. Return to Fn000 and press [DSPL/SET] to return to the initial screen, which will still
display “A.CC” until the machine is rebooted.
16. Reboot the machine and confirm that “bb” or “run’ displays on the amp.
SMT Equipment Quality Assurance Dept.
2 – 1 CS Section
FK-9F98-34 XP Type II Series Training Text for Service Engineers
Edition 2.0 XP142E – Chapter 2 Origin settings Page 2 of 6
Fuji Machine Mfg. Co., Ltd. Okazaki
2.2 Checking the R, Q and Z Servo Parameters
1. The R, Q, and Z servo axis amplifiers in the side 2 electric box are 3∑ amplifiers.
Side 2 Electric Box
Q Z
R
3∑ Servo Amplifiers
2. To check the servo parameters connect a digital operator (JUSP-OPO5A) to the relevant
amp.
3. After connecting the digital operator to the amplifier the following screen displays:
4. Use the LEFT and RIGHT arrow keys to select the “Un” segment of the “Un00” entry in
the second line of the digital display.
SMT Equipment Quality Assurance Dept.
2 – 2 CS Section