00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第283页
User Manual SIPLACE CA-Series 5 Setting up and Commissioning From software version SC.708.0 Edition 12/20 14 EN -DRAFT 5.5 Setting Up the Placement Machine 283 5 Fig. 5.5 - 2 Outer machine feet - two versions (dimensions…
5 Setting up and Commissioning User Manual SIPLACE CA-Series
5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
282
5
5
5
5
Lift the placement machine about 35 cm with the fork-lift truck. This prevents the risk of any
injuries to your feet if the machine feet are unintentionally lowered.
The placement machine stands on 6 feet.
– 4 outer machine feet (item 1 in fig. 5.5 - 3
, page 284)
The outer machine feet are available in two versions: 5
– Outer machine foot for PCB conveyor heights 900, 930 and 950 mm, Length 439 mm
[03000890-02] (item 2 in fig. 5.5 - 2
).
– 2 middle machine feet (item 2 in fig. 5.5 - 3
, page 284) with 2 spacers (item 3 and 4 in fig. 5.5
- 3, page 284) for height adjustment, where necessary.
WARNING
Please note the following points before you raise the machine, in order to avoid irre-
versible damage to the machine.
WARNING
Risk of damage due to excessive fork spacing!
The distance between the machine feet is 776 mm. Increased fork spacing, which means
that the machine is raised at points outside its contact surface, could lead to deformation
of the machine frame and cause damage to cables and lines.
The forks may only be opened to a degree which ensures that they are still within the
contact area of the machine underside (for contact surfaces see fig. 5.5 - 1
, page
281
).
WARNING
Risk of damage due to one-sided loading!
One-sided loading of the machine feet e.g. from tilting the machine, could lead to defor-
mation of the machine feet.
Make sure that the forks are evenly loaded when you lift the machine.
Use a firm support layer between the forks and the machine.
Enlist the help of a second person to watch while you lift the machine and make sure
that the machine does not tip over to one side.
User Manual SIPLACE CA-Series 5 Setting up and Commissioning
From software version SC.708.0 Edition 12/2014 EN -DRAFT 5.5 Setting Up the Placement Machine
283
5
Fig. 5.5 - 2 Outer machine feet - two versions (dimensions in millimeters)
5 Setting up and Commissioning User Manual SIPLACE CA-Series
5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
284
5
Fig. 5.5 - 3 Placement machine feet
5
(1) Outer machine foot, 4 x, 2 versions (see fig. 5.5 - 2, page 283)
(2) Middle machine foot, 2 x
(3) Spacer on the side of the power supply unit
(4) Spacer on the side of the pneumatic unit
(5) Threaded hole for the middle machine foot
(T) Direction of PCB transport
(P) Pneumatic unit
(S) Power supply unit