00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第400页
7 Component and Die Handling User Manual SIPLACE CA-Series 7.1 X Feeder Modules for SIPLACE X-Series From software version SC.708.0 Edition 12/2014 EN -DRAFT 400 7.1.1.5 Design of T ape Feeder Module for SI PLACE X-Serie…
User Manual SIPLACE CA-Series 7 Component and Die Handling
From software version SC.708.0 Edition 12/2014 EN -DRAFT 7.1 X Feeder Modules for SIPLACE X-Series
399
7.1.1.4 Tape Feeder Module Geometry for the SIPLACE X-Series
In general, the tape feeder modules from the X-Series are approx. 587 mm long and approx. 200
mm high. The width and the number of locations that it fills on the changeover table are listed in
the following table.
7
The maximum height of the interference contours above the upper edge of the tape pocket is ≤ 3
mm. As the feeder modules do not show any flaps projecting upwards and are also fixed to the
changeover tables, the risk of a head crash is reduced to a minimum.
Tape feeder
modules
Feeder module width in
millimeters
Feeder module locations
occupied on the changeover
table
4 mm 10.8 1
2x8 mm X 22.6 2
8 mm X 10.8 1
Smart Feeder 12 mm X 22.6 2
Smart Feeder 16 mm X 22.6 2
24 mm X 34.4 3
32 mm X 46.2 4
44 mm X 58.0 5
56 mm X 69.8 6
72 mm X 81.6 7
88 mm X 105.2 9
7 Component and Die Handling User Manual SIPLACE CA-Series
7.1 X Feeder Modules for SIPLACE X-Series From software version SC.708.0 Edition 12/2014 EN -DRAFT
400
7.1.1.5 Design of Tape Feeder Module for SIPLACE X-Series
The two following diagrams show the design of the tape feeder module for the X-Series with ref-
erence to the 8 mm X tape feeder module.
7
Fig. 7.1 - 1 Tape feeder module 8 mm X - front view
(1) Locking roller (the locking latch of the changeover table locks the feeder module in its end
position with the locking roller.)
(2) EDIF (energy and data interface)
(3) "Front" centering pin
(4) Lever for raising the pick-up window in order to thread in and remove the component tape
(5) Pickup window
(6) Tape guide channel outlet
(7) Setting the cover foil tension
(8) Cover foil rocker
(9) Cover foil packing wheels
(10) "Back" centering pin
(11) Type plate
User Manual SIPLACE CA-Series 7 Component and Die Handling
From software version SC.708.0 Edition 12/2014 EN -DRAFT 7.1 X Feeder Modules for SIPLACE X-Series
401
7
Fig. 7.1 - 2 Tape feeder module 8 mm X - back view
(1) Entry to the tape guide channel with tape spring
(2) Flap on cover foil container
(3) Integrated blade for cutting off the cover foil
(4) Removal handle, engaged
(5) Operator panel
(6) Drive motor for the cover foil packing device
(7) Drive motors for the tape conveyor
(8) Rotary valve for removing components
(9) Front slider guide
(10) Back slider guide
(11) Graphical representation of the pick-up position in relation to the component size