00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第369页
User Manual SIPLACE CA-Series 6 Working with the Machine From software version SC.708.0 Edition 12/ 2014 EN -DRAFT 6.6 Performing a Sight Check 369 6.6.6 Using Spindles for Large T ape Reels 6 6 Fig. 6.6 - 4 SIPLACE X-Se…
6 Working with the Machine User Manual SIPLACE CA-Series
6.6 Performing a Sight Check From software version SC.708.0 Edition 12/2014 EN -DRAFT
368
6.6.5 Inserting Separating Plates into the Tape Container
The separating plate has different edges and can be inserted into the tape container in two
ways. If spindles are used, the recesses for the spindles in the separating plate point upwards
(see item 4 in fig. 6.6 - 3
). If you do not use spindles, the rounded edge of the separating
plate points up (see item 5 in fig.
6.6 - 3
).
Insert the separating plates as shown in fig. 6.6 - 3 and remember that the smallest division
of the tape container is a 2x division. This will help avoid placement errors.
Check that the separating plates engage in the same positions on the three guide rails. Oth-
erwise the separating plate will be offset or bent.
6
Fig. 6.6 - 3 Separating plates in the tape container
(1) Guide rail for the separating plates
(2) Waste tape container
(3) Tape container
(4) Position of the separating plate if spindles are used
(5) Position of the separating plate if no spindles are used
(6) Sliding support for tape reels
User Manual SIPLACE CA-Series 6 Working with the Machine
From software version SC.708.0 Edition 12/2014 EN -DRAFT 6.6 Performing a Sight Check
369
6.6.6 Using Spindles for Large Tape Reels
6
6
Fig. 6.6 - 4 SIPLACE X-Series component trolley, with tape container and spindle
(1) Component trolley
(2) Position of the spindle
(3) Waste tape container
(4) Tape container
(5) Separating plate
(6) Spindle (zoom)
6
PLEASE NOTE
Using spindles
SIPLACE X-Series component trolleys do not generally need spindles.
Use spindles if the error message "Timeout" appears frequently on the X feeder mod-
ule.
6 Working with the Machine User Manual SIPLACE CA-Series
6.7 Configuring the Feeder Modules From software version SC.708.0 Edition 12/2014 EN -DRAFT
370
6.7 Configuring the Feeder Modules
6.7.1 Notes on Handling Feeder Modules
Feeder modules are precision devices. You should therefore handle the feeder modules with care.
Avoid bumping feeder modules into obstacles.
Do not drop the feeder modules.
Always use suitable tools for preventive maintenance.
6.7.2 Removing X Feeder Modules from the Changeover Table
6
Fig. 6.7 - 1 Removing X feeder modules from the changeover table
(1) Removal handle
(2) Status display
(3) LCD display
(4) Latch for locking the X feeder modules