00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第376页
6 Working with the Machine User Manual SIPLACE CA-Series 6.7 Configuring the Feeder Modules From software version SC.708.0 Edition 12/2014 EN -DR AFT 376 Guide the start of the t ape beneath the pickup window (item 2 i…
User Manual SIPLACE CA-Series 6 Working with the Machine
From software version SC.708.0 Edition 12/2014 EN -DRAFT 6.7 Configuring the Feeder Modules
375
Shorten the component tape with the exposed component pockets by around 3 cm.
Remove the components from the open tape pockets.
Wrap the cover foil around the front edge of the tape along the bottom of the tape.
6.7.4.3 Inserting the Tape into the X Feeder Module
6
Fig. 6.7 - 4 Inserting the component tape
(1) Entry to the tape guide channel
(2) Operator panel
(3) Tape guide channel outlet
(4) Pickup window
(5) Lever for raising the pickup window
6
Hold the component tape so that the transport holes are on the left-hand side viewed in the
direction of travel.
Push the component tape into the entry (item 1 in fig. 6.7 - 4) to the tape guide channel and
further until it emerges from the exit opening (item 3 in fig. 6.7 - 4
).
Pull the component tape up and out, and fold the cover foil back against the top of the tape.
6 Working with the Machine User Manual SIPLACE CA-Series
6.7 Configuring the Feeder Modules From software version SC.708.0 Edition 12/2014 EN -DRAFT
376
Guide the start of the tape beneath the pickup window (item 2 in fig. 6.7 - 5) and further until
the component tape is touching the sprocket wheel.
6
Fig. 6.7 - 5 Pickup window on the tape feeder module
(1) Tape support, removable
(2) Pickup window
(3) Removal edge for the cover foil
(4) Component pickup area
(5) Lever for raising and latching the pick-up window
User Manual SIPLACE CA-Series 6 Working with the Machine
From software version SC.708.0 Edition 12/2014 EN -DRAFT 6.7 Configuring the Feeder Modules
377
On the operator panel, press the FORWARD button (item 1 in fig. 6.7 - 6) until the bend of
the cover foil is in the component pickup area (item 4 in fig. 6.7 - 5
).
6
Fig. 6.7 - 6 Operating panel of feeder module
(1) FORWARD button for moving the component tape forward
(2) BACK button for moving the component tape back
(3) FOIL button for tensioning the cover foil
Push the lever (item 5 in fig. 6.7 - 5) forward in order to raise the pickup window (item 2 in fig.
6.7 - 5
) to the first position.
Pull the cover foil at the side of the pick-up window forward and out underneath the pick-up
window.
Fold the cover foil back until it lies against the pull-off edge (item 3 in fig. 6.7 - 5).
6
Push the lever (item 5 in fig. 6.7 - 5) back, to lower the pick-up window.
Guide the cover foil over the cover foil rocker (item 2 in fig. 6.7 - 7) until it reaches the foil
packing wheels (item 1 in fig. 6.7 - 7
).
PLEASE NOTE
Do not lower the pick-up window until the cover foil is lying against the pull-off edge.