00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第284页
5 Setting up and Commissioning User Manual SIPLACE CA-Series 5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DR AFT 284 5 Fig. 5.5 - 3 Placement machine feet 5 (1) Outer machine fo…
User Manual SIPLACE CA-Series 5 Setting up and Commissioning
From software version SC.708.0 Edition 12/2014 EN -DRAFT 5.5 Setting Up the Placement Machine
283
5
Fig. 5.5 - 2 Outer machine feet - two versions (dimensions in millimeters)
5 Setting up and Commissioning User Manual SIPLACE CA-Series
5.5 Setting Up the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
284
5
Fig. 5.5 - 3 Placement machine feet
5
(1) Outer machine foot, 4 x, 2 versions (see fig. 5.5 - 2, page 283)
(2) Middle machine foot, 2 x
(3) Spacer on the side of the power supply unit
(4) Spacer on the side of the pneumatic unit
(5) Threaded hole for the middle machine foot
(T) Direction of PCB transport
(P) Pneumatic unit
(S) Power supply unit
User Manual SIPLACE CA-Series 5 Setting up and Commissioning
From software version SC.708.0 Edition 12/2014 EN -DRAFT 5.5 Setting Up the Placement Machine
285
5.5.4.1 Presetting the Height of the Middle Machine Feet
The middle machine feet are initially preset. Depending on the placement machine height, you
may need to screw the spacer to the underside of the machine.
Setting a Board conveyor Height of 900 mm 5
You need a spacer for a board conveyor height of 900 mm.
Make sure that the 90 mm side of the spacer is vertically aligned and the hole for the middle
machine foot indicates downwards.
5
5
5
5
5
5
5
5
5
5
5
5
Fig. 5.5 - 4 Aligning the spacer for a conveyor height of 900 mm
5
(1) Spacer height of 90 mm
(2) Middle machine foot
(3) Lock nut M24
(4) Hexagon socket head screw M12x80, 4
Screw the thread of the middle machine foot into the hole provided on the underside of the
spacer.
Align the two spacers on the machine underside as follows:
– The spacer opening on the pneumatic unit side points in the direction of board conveyor
travel (see item 4 in fig. 5.5 - 3
, page 284).
– The spacer opening on the power supply side points in the opposite direction to that of
conveyor travel (see item 3 in fig. 5.5 - 3
, page 284).
Fasten each of the two spacers with four hexagon socket-head screws M12x80 (see item 4
in fig. 5.5 - 4
). Use the screwdriver bit of size 10 mm.