00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第69页
User Manual SIPLACE CA-Series 2 Operational Safety From software version SC.708.0 Edition 12/20 14 EN -DRAFT 2.5 Safety Instructions for Transportation 69 2.5.2 T ransporting the SWS 2 The SWS can be transported using a …
2 Operational Safety User Manual SIPLACE CA-Series
2.5 Safety Instructions for Transportation From software version SC.708.0 Edition 12/2014 EN -DRAFT
68
2.4.3 Laser Class 2
The following modules are assigned to laser class 2:
– Laser light barrier, placement area 1 in the PCB conveyor
– Laser light barrier, placement area 2 in the PCB conveyor
– PCB barcode scanner
– Component sensor on the SIPLACE SpeedStar (C&P20 M)
– Component sensor on MultiStar (CPP)
2
2.5 Safety Instructions for Transportation
2.5.1 Transporting the Placement Machine
2
Use a fork-lift truck with the following specification to carry the machine:
Fork length:Min. 1800 mmCarrying power:Min. 6000 kgClear width between forks:Min. 350
mm 2
2
2
Laser radiation
Do not look into beam!
WARNING
Risk of tilting!
Risk of tilting, if the required specifications for the fork-lift truck are not observed.
Only use the specified fork-lift for transportation.
Transportation of the machine is described in section 5.2
, page 257.
User Manual SIPLACE CA-Series 2 Operational Safety
From software version SC.708.0 Edition 12/2014 EN -DRAFT 2.5 Safety Instructions for Transportation
69
2.5.2 Transporting the SWS
2
The SWS can be transported using a suitable hand lift with the following specifications:
Carrying power 1000 kg at least
Fork length 1000 mm at least
Distance between the forks 300 at least, 520 mm at most (outer dimension) 2
2
WARNING
Risk of tilting!
There is a risk of the SWS tilting if the required specifications for the fork-lift truck are not
observed.
Only use the specified fork-lift for transportation.
Transportation of the SWS is described in section 5.3
, page 266.
PLEASE NOTE
Hand lift specifications
The necessary width of the fork lift presents a critical measure.
Make sure that the hand lift used fulfills the specified requirements.
2 Operational Safety User Manual SIPLACE CA-Series
2.6 Safety Instructions for Operating the Placement Machine From software version SC.708.0 Edition 12/2014 EN -DRAFT
70
2.6 Safety Instructions for Operating the Placement
Machine
2.6.1 Safety Instructions for Closing the Protective Covers
To avoid risk of injury when closing the protective covers on the machine, the operator must in-
struct the personnel concerned to always follow the instructions below when handling the protec-
tive covers.
2
2
Fig. 2.6 - 1 Safety instructions for closing the protective covers
(1) Protective Covers
(2) Handles
(3) Cover flaps above the PCB conveyor
(4) Warning strips
(5) SWS sliding door
CAUTION
Danger of crushing!
Risk of crushing hands if the protective covers are not closed correctly.
Close the protective covers correctly.