00197498-03_UM_SiplaceCA-Serie_EN.pdf - 第456页
8 Station Extensions User manua l SIPLACE CA-Series 8.1 Nozzle Changers From software version SC.708.0 Edition 12/2014 EN -DRAFT 456 8 Fig. 8.1 - 7 Changing the magazine (1) Lever for raising the magazine (2) Parallel pi…
User manual SIPLACE CA-Series 8 Station Extensions
From software version SC.708.0 Edition 12/2014 EN -DRAFT 8.1 Nozzle Changers
455
8.1.2.5 Notes on Operation
When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label
to identify the type.
8
Open the locking plate and place the nozzles in the nozzle holders.
Close the locking plate so that the nozzles cannot drop out of the magazines.
8
8
Programming the nozzle changer is described in the SIPLACE Pro user manual.
8.1.2.6 Changing the Magazine
Press the lever (item 1 in fig. 8.1 - 7), to release the magazine from the snap fasteners.
PLEASE NOTE
Fill the magazines off the machine and always replace complete magazines.
CAUTION
Filling up magazines!
Before you fill magazines, make sure that all the nozzles on the Collect&Place head
have
been returned to their magazines.
PLEASE NOTE
Risk of jamming!
If components fall onto magazines, there is a risk that the locking plate could jam.
Do not allow components to drop onto the magazines.
You should therefore regularly clean the magazines and free locations.
WARNING
Risk of head crashes with protruding lever!
Any lever that is protruding over the magazine (item 1 in fig. 8.1 - 7
) could lead to a head
crash.
You should therefore make sure that the lever does not protrude over the magazines.
8 Station Extensions User manual SIPLACE CA-Series
8.1 Nozzle Changers From software version SC.708.0 Edition 12/2014 EN -DRAFT
456
8
Fig. 8.1 - 7 Changing the magazine
(1) Lever for raising the magazine
(2) Parallel pin, engages in the hole in the magazine
(3) Spring pin for triggering the microswitch
(4) Pin of the slide mechanism, moves the locking plate
(5) Ball of snap fastener
(6) Parallel pin, engages in the slot in the magazine
(7) Locking plate in the "magazine locked" position
8
PLEASE NOTE
Move the locking plate into the "Magazine locked" position.
Before inserting, align the magazine so that the centering pins (item 2 and 6 in fig. 8.1
- 7) can slide into the centering hole and the slot (item 6 in fig. 8.1 - 6) .
User manual SIPLACE CA-Series 8 Station Extensions
From software version SC.708.0 Edition 12/2014 EN -DRAFT 8.1 Nozzle Changers
457
Place the magazine on the snap fastener balls (item 5 in fig. 8.1 - 7).
Press the magazine down evenly so that the snap fastener balls engage in all the snap fas-
teners at the same time.
8.1.2.7 Position detection
Each magazine of the nozzle changer has two fiducials: one for determining the position and one
for determining the angular position.
8
Fig. 8.1 - 8 Nozzle magazine - garage numbering, fiducials for determining the position and angular position
(1) Locking plate in the "magazine open" position
(2) Fiducial for determining the position
(3) Fiducial for determining the angular position