YRM20_Ope_E.pdf - 第132页

3. Displaying the production monitors 2-35 Chapter 2 Basic operation 3.7 Badmark T he [Badmark] screen shows the recognition results of badmarks suc h as "Board, Block" and "Local" badmarks. Monitor: …

100%1 / 220
3. Displaying the production monitors
2-34
Chapter 2 Basic operation
3.6 Fiducial
The Fiducial screen shows the results of recognizing fiducial marks such as “Board, Block”, “2 Point Local”
and “Point” and the correction result.
Monitor: Fiducial
24217-KMX-00
• Table Select
Select a head unit.
• Fiducial Type
Select the type of the fiducial mark such as "Board, Block", "2Point Local" or "Point".
• Align X, Y, R
Shows the differences between the fiducial mark recognition results and the input coordinate entered in
the board data with positive or negative values.
• Align Ratio
Shows the rate of expansion of the board, calculated by using the X, Y and R offset values.
• Result
Shows the recognition results as a "Pass" or "Unfinished ". The "Unfinished" message changes to "Pass" after the
mark has been recognized successfully.
3. Displaying the production monitors
2-35
Chapter 2 Basic operation
3.7 Badmark
The [Badmark] screen shows the recognition results of badmarks such as "Board, Block" and "Local"
badmarks.
Monitor: Badmark
24218-KMX-00
• Table Select
Select a head unit.
• Badmark Type
Select the type of the badmark such as "Board, Block" or "Local".
• X, Y
Shows the board data input values (by taking block offset amount into account).
• Result
Makes an "OK" or "NG" decision based on the badmark recognition result.
OK: Failed in recognizing a bad mark: Means components are mounted.
NG: Succeeded in recognizing a bad mark: Means components are not mounted.
3. Displaying the production monitors
2-36
Chapter 2 Basic operation
3.8 Pick Pos. (Pickup position offset)
n
NOTE
Pickup position offset function applies to the components satisfying the following conditions.
• The correct Mode on [Machine] - [Specification Information] - [Pick Position Specification] is set to either "Use" or "Use
with Feeder Correction".
• Component picked up with a nozzle that the "Available" on [Machine] - [Specification Information] - [Pick Position
Specification] is set to "Use".
• Component that "E: Pick Pos Correction" is set to "Use" on [Parts] - [Option] tab screen of the board data.
This screen appears when the pickup position offset function is used. This screen allows to check how the
pickup position of the object component (feeder) is corrected. If either the X or the Y correction amount
exceeds the warning zone or the error zone set up in the machine setting, the corresponding component in
the components list changes its color.
►
Display color
Color of row Status Description
Yellow Warning
Exceeds warning level figure for each nozzle data set in pickup position offset
specifications.
Red Error
Exceeds error level figure for each nozzle data set in pickup position offset
specifications.
n
NOTE
Warning generated : The machine generates an error message. The yellow lamp on the signal lamp tower flashes.
The machine, however, can continue the operation.
Experiencing error : The machine generates an error message when finishing producing one board.
The machine cannot continue the operation.
n
NOTE
The numerical values specified in the warning level and error level of the pickup position offset specification are machine
data setting items. Accessing such parameters require the administrator level of authority.
Monitor: Pick Pos. (Pickup position offset)
24219-KMX-00