YRM20_Ope_E.pdf - 第186页
1. Flow from starting up machine to production 3-6 Chapter 3 Flow from starting up machine to production 2 A ssig n the oper ator . 1. Pull down the “Operators” (Group name) on the “ID window” (operator window) and selec…
1. Flow from starting up machine to production
3-5
Chapter 3 Flow from starting up machine to production
1.3 Selecting the operator
Assign the operator who operates the machine.
Normally, register the operator names and operation authorities (and passwords, if necessary) in advance
and select the operator from those registered.
At the time of shipping, two operators or operator groups were registered - The “Administrator” (“A group of
administrators)” who have all the complete operation authorities and the “Default operator” (“A group of
default operators”) who have a fewer operation authorities.
TIP
Active menu buttons differ depending on the operation level setup. For example, when the machine is turned on with the
factory setup, the program starts up at an operation level called "Default Operator". This "Default Operator" level is set to
"Level 0" at the time of shipment to allow only basic operation items. This operation level can be changed as needed.
Operators and operation items can also be added and specified by setting the password and operation level.
For more details, see “Programming Manual".
1
Press the [Operator] button.
The ID WINDOW screen appears for specifying the operator.
[Operator] button
[Operator] button
24301-KMX-00
1. Flow from starting up machine to production
3-6
Chapter 3 Flow from starting up machine to production
2
Assign the operator.
1. Pull down the “Operators” (Group name) on the “ID window” (operator window) and select an
“Administrator” or “Operator”.
2. Select the “Operator”.
3. (If passwords are used) Enter the corresponding password.
4. Press the [OK] button. The initial screen (the setup screen before selecting a board) appears on
the display.
Specifying the operator
Select group name.
Enter password.
Select operator name.
24302-KMX-00
1. Flow from starting up machine to production
3-7
Chapter 3 Flow from starting up machine to production
1.4 Warming up the machine
After starting up the machine, we recommend warming it up for about 10 minutes in most cases. If less than
two hours has elapsed after the machine was last used, no warm-up is necessary.
1
Press the [Warm Up] button on the Setup screen.
The Warm-up screen then appears.
2
Enter a warm-up time.
Press the [Stop after time over] button and enter the warm-up time. Warm-up will automatically stop
when the warm-up time you set has elapsed. Normally, about a 10-minute warm-up is sufficient.
Warm-up time setting
[Setup] screen
[Stop after time over] button“Warm up” screen
[Warm Up] button
24303-KMX-00