YRM20_Ope_E.pdf - 第196页
1. Flow from starting up machine to production 3-16 Chapter 3 Flow from starting up machine to production 2 Mo ve do wn the Board cl amp plate. Press [ Board C lamp] button in [U nit] - [ Conveyor] s creen to m ove down …
1. Flow from starting up machine to production
3-15
Chapter 3 Flow from starting up machine to production
1.6.2 Adjusting board hold plate position
1
Enter the board.
1. Press the [Convey Board] button on [Unit] - [Conveyor] screen.
2. The "Convey Boards" check screen appears. Confirm that "All position" is ticked, and then
press the [OK] button.
3. The "CONVEY AND FIX" screen appears. Set the board on the conveyor entrance of the
machine.
4. Pressing the [OK] button on the "CONVEY AND FIX" screen transfers the board and fixes it on
the mount position.
Entering board
[Unit] - [Conveyor] screen
[Convey Board] button
Set a board and press
the [OK] button
Tick "All position"
Tick “Board fix”
24310-KMX-00
1. Flow from starting up machine to production
3-16
Chapter 3 Flow from starting up machine to production
2
Move down the Board clamp plate.
Press [Board Clamp] button in [Unit] - [Conveyor] screen to move down the board clamp plate.
Moving down the board clamp plate
[Unit] - [Conveyor] screen
Stage 1 [Board Clamp] button
Stage 2 [Board Clamp] button
24311-KMX-00
1. Flow from starting up machine to production
3-17
Chapter 3 Flow from starting up machine to production
e
3
Adjust the board hold plate positions.
1. Press the [EMERGENCY STOP] button.
2. Unclamp the carriage and detach it.
3. Open the machine safety cover, and remove the upper cover when needed.
4. Loosen the screws on the board hold plates with Phillips screw driver. It is not required to
detach them.
5. Move the board hold plates to the side according to the size and shape of the board.
6. Tighten the screws on the board hold plates.
TIP
The board hold plate overlaps the board by 3 mm (the length of the portion of the board hold plate over the board is 3
mm).
Adjusting the board hold plate positions
Dual stage : Stage1
Phillips screw driver
Board hold plates
Loosen screws to slide board hold plate.
• Board hold plates are not uniformly laid out.
• Board hold plate is too close to a
component mounting position.
Tips for adjusting the board hold plates
• Board hold plates are uniformly laid out.
• There is no obstacles such as a slit near to plate.
• The number of plates is insufficient.
• Board hold plate holds
a portion with a slit.
Slide the board hold plate.
3mm
23305-KMX-00