YRM20_Ope_E.pdf - 第157页
4. Preparing component tape 2-60 Chapter 2 Basic o pera tion 5 Check th e state of setting in fe eder . View the fee der from the side t o see t hat “the t ape guide assembly is not lift ed”, “the fe eder positioni ng pi…
4. Preparing component tape
2-59
Chapter 2 Basic operation
3
Set ZS feeder to carriage.
1. Grip the unclamping lever of a feeder.
2. Confirm the setting number on the carriage.
3. Place the feeder temporarily with its under rail aligned with the guide on the feeder plate side.
4. While keeping gripping the unclamping lever firmly, slide the feeder on the feeder plate to
insert the feeder to the end.
c
CAUTION
Be careful not to insert the feeder with excessive force.
Also, grip the unclamping lever firmly, or the clamping lever assembly does not open enough.
Feeder exchange carriage
Setting ZS/ZSR feeder
Check the setting number.
Unclamping lever
Under rail
Clamping lever assembly
23215-KMX-00
4
Lock the clamping lever assembly.
Upon releasing the unclamping lever, the clamping lever assembly closes and locks.
Confirm that the clamping lever assembly is locked firmly and the feeder does not come off.
Otherwise, the feeder may come off while mounting.
4. Preparing component tape
2-60
Chapter 2 Basic operation
5
Check the state of setting in feeder.
View the feeder from the side to see that “the tape guide assembly is not lifted”, “the feeder
positioning pin equipped at the front end of front block is inserted to the end of feeder positioning
hole” and “the under rail of the feeder firmly, correctly sits in the feeder plate guide”.
Checking the state of setting in feeder
ZSR feeder viewed from side
Under rail
Tape guide assembly
Feeder plate guide
Front block
Feeder positioning hole
23216-KMX-00
4. Preparing component tape
2-61
Chapter 2 Basic operation
4.1.3 Attaching the feeder exchange carriage on the mounter
This section describes the procedure to attach the feeder exchange carriage on the mounter. See "4.2 SS
Feeder" in this chapter for procedure of attaching the feeder exchange carriage with SS feeder to mounter.
1
Clean around the clamp units of the machine.
Before attaching the carriage on the mounter, remove the dust or foreign matter around the clamp
units of the carriage at machine side. Use the feeder plate cleaning brush that comes with the
machine, a vacuum cleaner (home use) or the vacuum assembly (option) to get rid of dust or foreign
matter around the clamp units.
Cleaning the clamp unit
Clamp unit
Receive dust with a dustpan
Cleaning brush
Clamp unit
23217-KMX-00
c
CAUTION
A connector unit supplying power and air to carriage is equipped at the carriage clamp unit. Some foreign matters
entering to the connector of the clamp unit might cause the short circuit to damage the equipment.