YRM20_Ope_E.pdf - 第168页
4. Preparing component tape 2-71 Chapter 2 Basic o pera tion 4.1.7 Detaching feeder from the feeder exchange carriage 1 Detach feeder from the carriage. 1. Grip the unclamping lever of feeder . 2. While gripping the uncl…
4. Preparing component tape
2-71
Chapter 2 Basic operation
4.1.7 Detaching feeder from the feeder exchange carriage
1
Detach feeder from the carriage.
1. Grip the unclamping lever of feeder.
2. While gripping the unclamping lever, pull the feeder straight out.
Feeder exchange carriage
Detaching ZS/ZSR feeder
Unclamping lever
23227-KMX-00
2
Detach the reel from the reel holder.
4. Preparing component tape
2-72
Chapter 2 Basic operation
4.1.8 Detaching component tape from feeder
n
NOTE
Always use a temporary tape set station (or a power station, if equipped) to detach the tape. Make sure to prevent
essentially to detach tape from tape feeder on feeder exchange carriage already attached to mounter, as a component
tape may fall inside of mounter upon working.
1
Set the feeder on the temporary tape set station.
1. Set the feeder on the temporary tape set station.
2. Set the tape reel on the reel holder of the temporary tape set station.
TIP
Upon detaching the component tape, it can be set to the set position without connector.
2
Dispose of the used cover tape.
Open the feeder tail cover and check if the used cover tape remains.
Dispose of the cover tape when appropriate.
TIP
See "4.1.5 Disposing of used cover tape and carrier tape" in this chapter for the detailed procedure.
3
Pull out the cover tape.
Press the take-up roller lever to make a clearance under the take-up roller. Then pull out the cover
tape from the clearance.
Pulling out cover tape
Pull out cover tape.
Take-up roller lever
Take-up roller
Reel
23228-KMX-00