YRM20_Ope_E.pdf - 第159页
4. Preparing component tape 2-62 Chapter 2 Basic o pera tion 2 P ut the ca rriage int o the mach ine. 1. Move the feeder exchange carriage in front of the position to attach the carriage. 2. While holding the carriage ha…
4. Preparing component tape
2-61
Chapter 2 Basic operation
4.1.3 Attaching the feeder exchange carriage on the mounter
This section describes the procedure to attach the feeder exchange carriage on the mounter. See "4.2 SS
Feeder" in this chapter for procedure of attaching the feeder exchange carriage with SS feeder to mounter.
1
Clean around the clamp units of the machine.
Before attaching the carriage on the mounter, remove the dust or foreign matter around the clamp
units of the carriage at machine side. Use the feeder plate cleaning brush that comes with the
machine, a vacuum cleaner (home use) or the vacuum assembly (option) to get rid of dust or foreign
matter around the clamp units.
Cleaning the clamp unit
Clamp unit
Receive dust with a dustpan
Cleaning brush
Clamp unit
23217-KMX-00
c
CAUTION
A connector unit supplying power and air to carriage is equipped at the carriage clamp unit. Some foreign matters
entering to the connector of the clamp unit might cause the short circuit to damage the equipment.
4. Preparing component tape
2-62
Chapter 2 Basic operation
2
Put the carriage into the machine.
1. Move the feeder exchange carriage in front of the position to attach the carriage.
2. While holding the carriage handle, put it into the mounter straight along the carriage guide.
3. Keep fixing the carriage by holding handles while inserting the carriage to the end.
n
NOTE
The feeder exchange carriage may deviate upon clamping depending on the installed position as the floor tilts.
Hold the handles to fix the feeder exchange carriage till the end of the carriage clamping of Step 3 to 4.
Putting the carriage into the mounter
Handles
Carriage guide
Carriage guide
23218-KMX-00
4. Preparing component tape
2-63
Chapter 2 Basic operation
3
Turn the clamp switch ON.
Turn the clamp switch corresponding the position where the carriage is inserted to left (ON), then the
carriage clamp unit at the mounter side moves down to clamp the carriage.
The LED indicator of the clamp switch starts blinking during clamping the carriate.
After that, the communication is checked automatically between the mounter, the carriage and the
feeders.
Carriage clamp switch
Clamping : Indicator blinks
Clamp switch
23219-KMX-00
4
Check the clamp switch light is on.
After the communication check between the mounter, the carriage and the feeders are completed, the
switch indicator is changed lighting. Unhold the carriage handles.
c
CAUTION
While the clamp switch is blinking, do not touch the inside of machine or carriage.
The clamp unit moving down might pinch hands.
n
NOTE
While the safety cover or the upper cover of the mounter is open, the clamp unit doesn't move down even with turning the
clamp switch.
n
NOTE
There is the sensor called "forward end sensor(FDR FORWARD SENSOR)" at far end of the carriage set position of the
mounter. When the carriage is inserted to far end, this sensor recognizes. When this sensor doesn't recognize the carriage,
the clamp units doesn't move down even with turning the clamp switch.
c
CAUTION
The deviation of carriage during clamping motion loads the clamp connector and the repetition of this motion may damage
the clamp connector.
Make sure to keep firmly the carriage handles to attach the carriage.