JANETS_INM.pdf - 第316页
JaNets In structio n Manual 7. Program Editor 7- 109 The relation bet wee n the compo nent pic k - up posit ion of the JaNet s and that of an RX - 7 serie s is shown in the t able below . (This is common to t he left s t…
JaNets Instruction Manual 7. Program Editor
7-108
Figure 7.4-150 Pick Form
* In the EPU mode, “Machine specification” is not displayed.
* When you use an RX-7 series, numbers for indicating a position at which a component supply
device is to be mounted are different from those of other machine models.
Feeders are assigned to odd-numbered slots. However, when you use an 8-mm type D feeder
on the lane 2, it is assigned to an even-numbered slot.
* When you use a JM-100, the bank type is displayed after the side, front or rear.
Figure 7.4-151 Bank type display
Display only in the line mode
JaNets Instruction Manual 7. Program Editor
7-109
The relation between the component pick-up position of the JaNets and that of an RX-7 series is
shown in the table below. (This is common to the left station and the right station.)
JaNets
RX-7 series
Hole
number
Lane Slot number
1
1
101
2
102
2
1
103
2
104
3
1
105
2
106
4
1
107
2
108
5
1
109
2
110
6
1
111
2
112
7
1
113
2
114
8
1
115
2
116
9
1
117
2
118
10
1
119
2
120
11
1
121
2
122
12
1
123
2
124
13
1
125
2
126
14
1
127
2
128
15
1
129
2
130
16
1
131
2
132
17
1
133
2
134
18
1
135
2
136
19
1
137
2
138
JaNets Instruction Manual 7. Program Editor
7-110
7.4.7 Editing the station data
This screen allows you to set data such as a production program when a production line includes a
machine other than a mounter or a dispenser.
Figure 7.4-151 Station data screen
Specify a production program used with each machine.
When you press the <Production program list> button, the system inquires of the machine for the pro-
duction program list, and then displays the “Production program list” on the screen.
Figure 7.4-152 Production program list screen
After selecting a production program to be used, press the <Select> button. The selected production
program is reflected in the station data.
Set data for each inspection machine
and/or printer of a production line.
When the machine model is an RV-1, RV-2 or
RV-2-3D, specify the distinction of a machine
and TOPSS, and the corresponding category
here. These fields do not appear on the
screen in case of a printer.