00191025-01.pdf - 第352页
SIPLACE 80S/F/G User’s Manual 8 Component Supply Edition 07/97 from S oftware Version SR.010.xx 8.6 Wafflepack Changer 8 - 27 - Key to Fig. 8.6.5 ➀ With so cket wrenc h UP/DOWN ➁ Clamping s crew ➂ Strok e ➃ Docking pin ➄…
8 Component Supply SIPLACE 80S/F/G User’s Manual
8.6 Wafflepack Changer Edition 07/97 from Software Version SR.010.xx
8 - 26
8.6.9 Fitting the Wafflepack Changer
●
Before you have the wafflepack changer move into the machine, remove the lighting of the component
vision module.
CAUTION
O
The wafflepack changer can be moved into and out of the machine on its wheels, but it should be noted that
these wheels are not suitable for moving the wafflepack changer over longer distances. DANGER OF OVER-
TURNING! In such cases use the suitable lift truck (from item no. 00123141-01).
●
Move the wafflepack changer carefully into the desired location in the machine.
The docking pins of the wafflepack changer must be located above the docking slots of the SIPLACE
machine.
●
Check the dimension (87 ± 0.5 mm) between lower edge of magazine carrier and top of components table
(see Fig. 8.6.5)
Fig. 8.6.5 Aligning the WPC
SIPLACE 80S/F/G User’s Manual 8 Component Supply
Edition 07/97 from Software Version SR.010.xx 8.6 Wafflepack Changer
8 - 27
- Key to Fig. 8.6.5
➀
With socket wrench UP/DOWN
➁
Clamping screw
➂
Stroke
➃
Docking pin
➄
Upper edge of the magnetic bar of the component table
➅
Lower edge of tray
➆
Nominal stroke (459 mm)
➇
Refill position (470 mm)
●
Undo the clamping screws at the feet (see Fig. 8.6.5) and using a 10 mm ball socket wrench rotate the
wafflepack changer downwards until the docking pin engages. The wafflepack changer must at this point
be aligned using the machine spirit level fitted to the wafflepack changer.
●
Tighten up the clamping screws and check the machine spirit level again.
●
Plug the lighting back into the components vision module.
8.6.10 Technical Data
Wafflepack-Changer
Length ca. 1475 mm
Width ca. 620 mm
Height ca. 1355 mm
Weight ca. 240 kg
Magazine size 238 mm x 338 mm
Vertical stroke 470 mm
Horizontal stroke 730 mm
Pitch 17 mm
Storage unit capacity 28 trays for holding flatpack magazines
Magazine carrier 260 mm x 360 mm
Max. weight of storage unit 50 kg
Floor load
< 25 N/cm
2
Changeover time (magazine/magazine)
≤
3 sec.
Tab. 8.6.1
8 Component Supply SIPLACE 80S/F/G User’s Manual
8.6 Wafflepack Changer Edition 07/97 from Software Version SR.010.xx
8 - 28