00191025-01.pdf - 第456页
SIPLACE 80S/F/G User’s Manual 9 Maintenance Edition 07/97 from S oftware Version SR.010.xx 9.8 Camera Systems and Coplanarity Las er Module 9 - 97 Key to Fig. 9.8.1 1 Detail Y 3 S ection X -X 2 Glass hol der 4 Surfaces t…
9 Maintenance SIPLACE 80S/F/G User’s Manual
9.8 Camera Systems and Coplanarity Laser Module Edition 07/97 from Software Version SR.010.xx
9 - 96
●
Place the illumination head back vertically on the component camera so that the fastening of the glass disk
points to the board conveyor. Make sure the illumination head has been pushed on as far as the stop.
Fig. 9.8.1 Cleaning the illumination head of the IC or FC camera
SIPLACE 80S/F/G User’s Manual 9 Maintenance
Edition 07/97 from Software Version SR.010.xx 9.8 Camera Systems and Coplanarity Laser Module
9 - 97
Key to
Fig. 9.8.1
1 Detail Y 3 Section X-X
2 Glass holder 4 Surfaces to be cleaned
∆
!
glass plate
5 Viewing IC illumination head
Sequence of work in
Fig. 9.8.1
A Clean these surfaces on all sides (applies to IC camera only) and only if the glass disk is dirty.
B Unscrew and remove the hexagon socket screws.
C Pull the glass holder diagonally downwards and away.
D Clean this area.
9.8.4 Coplanarity Laser Module (SIPLACE 80F)
9.8.4.1 Safety Instructions
DANGER
∆
!
∆
!
∆
!
The coplanarity laser module when without safety
devices corresponds to laser class 3B: the laser
works in a wavelength and power range which is
dangerous for eyes and skin.
Only when the safety features have not been mod-
ified does the module correspond to laser class 1
and can be operated without endangering others.
For this reason do not modify or tamper with the
safety devices.
NOTE
Safety devices for operating the laser module in laser class 1:
The safety plug in the laser module will prevent the laser being operated outside the machine.
When one of the safety hoods is opened the operating voltage will be interrupted and the operating voltage
LED will go out at the laser module.
This safety feature will remain in force even when the key-operated switch has been operated (unlocked).
DANGER
∆
!
∆
!
∆
!
Switch off the automatic placement machine at the main switch and disconnect from the power supply before
carrying out maintenance work.
K
INVISIBLE LASER RADIATION
DO NOT EXPOSE TO BEAM
LASER CLASS 3 B
2.4 MW MAX., 750 NM;
AS PER IEC 825-1(1993)
K
9 Maintenance SIPLACE 80S/F/G User’s Manual
9.8 Camera Systems and Coplanarity Laser Module Edition 07/97 from Software Version SR.010.xx
9 - 98
9.8.4.2 Cleaning the Glass
●
Switch the machine off at the main switch. Open the sliding safety doors.
●
Clean the glass disk of the coplanarity laser module (see Fig. 9.8.2) with a clean and dry lens cloth.
●
Close the safety hoods and switch the machine on at the main switch.
Fig. 9.8.2 Cleaning the glass disk of the coplanarity laser module
Key to Fig. 9.8.2
1 Direction of PCB transport
2 Nozzle changer
3 Coplanarity laser module
4IC camera
5FC camera
Sequence of work in Fig. 9.8.2
A Clean the glass surface with a lens cloth.