SG_FSE_SiplaceHF_HF3_00193901-05_eng.pdf - 第333页
1 - 21 S tudent Guide SIPLACE HF/HF3 Edition 09/2005 7 TWIN-Head 21 7.4.1.2 Vision board The vision board is connect on th e top of the head interface. That board is al so used on the gantry 1 with a C&P head. Fig. 7…
1 - 20
Student Guide SIPLACE HF/HF3
7 TWIN-Head Edition 09/2005
20
Description LED‘S and DIP switch head interface: 7
LED 1-7 (functional check)
– SPI - Serial parallel interface (A/D or D/A converter in future)
– D-ON - Digital ON 5V DC/DC Converter
– H-OK - Head adapter board connected
– C-In - CAN Internal not used
– MRST - Main Reset
– F-UC- not used
– MP - Main Power fail, indicates 5 V power supply being missing at the machine (e.g. CAN
Bus)
LED 1-10 (LED´s for voltages)
– Vcc - Power supply +5 V head interface
– N15V - Minus 15 Volt (from the Axis unit--> Error--> LED red)
– P3,3V - not used
– P15V - Plus 15 Volt (from the Axis unit--> Error--> LED red)
– P24V - 24 Volt power supply (e.g.stepper motor)
– AV ER - not used
– EN AN - not used
– P5V - 5 Volt Power supply track signals X-Axis --> ON Power fail
– VccF - 5 Volt for digital
– TMP - Temperature monitoring X-Axis
Please Note:
The DIP Switch configuration for the gantry configuration is decribed in chapter gantry.
1 - 21
Student Guide SIPLACE HF/HF3
Edition 09/2005 7 TWIN-Head
21
7.4.1.2 Vision board
The vision board is connect on the top of the head interface. That board is also used on the
gantry 1 with a C&P head.
Fig. 7.4 - 2 Vision board
1. Connector illumination PCB camera
2. Connector video signals PCB camera
3. LED‘s P15V - 15Volt / Vcc - Power supply Vision board
4. DIP Switch
5. CAN Processor 16 Bit (additional board on the Visionboard)
6. DC/DC Converter 15 --> 5V for Visionsystem
Please Note:
The DIP Switch configuration for the gantry configuration is decribed in chapter gantry .
4
5
1
3
2
6
1 - 22
Student Guide SIPLACE HF/HF3
7 TWIN-Head Edition 09/2005
22
7.4.1.3 CAN Processorboard 16 Bit
The 16 BIT CAN Processor is used for different functions of the following units:
– Visionboard, Communication and control via the ICOS system
– Mainboard Twin head, control the Vacuum generator
– Visionboard for the stationary IC (FC) - Camera, communication and control via the ICOS
system
Abb. 7.4 - 3 16 Bit Processor
Description 7 Segment display ( Standard mode " . " flashed):
– After switch ON the machine " 0 " appears on the display
– Display " b " Bios is started.
– Display flash alternately "b" and " . " --> none Application available or can not started.
– Display " -I " und " I- " Application is loaded and now starts.
– The " . " on the display flashed.
(1) 7 Segment display
(2) LED red at the bei manual RESET
on the Processors
(3) 16 Bit Processor
2
3
1