SG_FSE_SiplaceHF_HF3_00193901-05_eng.pdf - 第50页
1 - 24 S tudent Guide SIPLACE HF/HF3 2 Overview Edition 09/2005 24 2.2.9 Position of the gantrys Fig. 2.2 - 14 Position of the gantries HF3 Legend: Please Note The HF machine have only two gantries. Th e na me of this Ga…
1 - 23
Student Guide SIPLACE HF/HF3
Edition 09/2005 2 Overview
23
2.2.8.3 Overview Tape feeders
Description: Only 9 different feeder sizes are needed to feed tapes from 8 mm to 88 mm. Reels
are kept in the tape container on the component changeover table. The table cutter automatically
cuts the used tape. SIPLACE feeders have short cycle times and highprecision pick-up positions.
The feeders can also be used in other SIPLACE placement machines.
Bulk case feeders, vibratory stick feeders, surftape feeders, dip flux modules, component return
modules, and manual trays may be set up in addition to the tape feeders. Dummy feeders are
used at unassigned locations to protect the operators.
Fig. 2.2 - 13 Overview feeders
1 - 24
Student Guide SIPLACE HF/HF3
2 Overview Edition 09/2005
24
2.2.9 Position of the gantrys
Fig. 2.2 - 14 Position of the gantries HF3
Legend:
Please Note
The HF machine have only two gantries. The name of this Gantries with Stationsoftware
505.xx is Gantry 1 and Gantry 3.
G1Gantry 1 G3Gantry 3
X1X-Axis, Gantry 1 X3X-Axis, Gantry 3
Y1Y-Axis, Gantry 1 Y3Y-Axis, Gantry 3
G4Gantry 4
X4X-Axis, Gantry 4 (T)Transport direction
Y4Y-Axis, Gantry 4
G4
G1
G3
Y4
Y3
Y1
X4
X3
X1
T
1 - 25
Student Guide SIPLACE HF/HF3
Edition 09/2005 2 Overview
25
2.2.10 Construction X-Axis
2
Fig. 2.2 - 15 Structure X-Axis
The X-Axis consist of the following main modules:
The gantry arm is identical on the original- and on the ’A’ machine version.
(1) Gantry X (Frame) (2)Mounting plate head with X-linear motor (pri-
mary part)
(3) Linear incremental encoder (4) Linear guides X-Axis
(5)Linear drive Permanent magnet (sec-
ondary part)
(6) PCB-camera
(7) head interface board (8)trailing cable X-Axis