SG_FSE_SiplaceHF_HF3_00193901-05_eng.pdf - 第398页

1 - 12 S tudent Guide SIPLACE HF/HF3 9 Modular convey or Edition 09/2005 12 Fig. 9.2 - 2 Measuring and setting th e belt t ension for the width adjustment (showing HS-60) Legend The belt is tensioned by means of cams on …

1 - 11

Student Guide SIPLACE HF/HF3

Edition 09/2005 9 Modular conveyor

9.2 Adjustments on the modular conveyor

Please Note:

When any settings are made on the lifting table, the lifting table must be secured to prevent it mov-

ing. Press the emergency stop button.

9.2.1 Belt tension adjustment

Please Note:

The belt tension must be measured at the center of the belt (strand center), i.e. in the middle

where the distance between two idler pulleys is largest.

Fig. 9.2 - 1 Measuring and setting the conveyor belt tension

Every conveyor section contains an idler pulley that can be moved.

Loosen the fixing screw

(1) and move this idler pulley in order to set the belt tension for the asso-

ciated conveyor belt

(2).

The belt tension is measured

at the longest point between

two idler pulleys.

Idler pulley: the belt tension is

set by moving the idler pulley.

1 - 12

Student Guide SIPLACE HF/HF3

9 Modular conveyor Edition 09/2005

Fig. 9.2 - 2 Measuring and setting the belt tension for the width adjustment (showing HS-60)

Legend

The belt is tensioned by means of cams on the idler pulleys. The idler pulleys are located on the

left and right of the motor.

Fig. 9.2 - 3 Width adjustment motor

(1) Driver (2) Spindle with toothed wheel

(3) Width adjustment stepping motor (4) Toothed drive belt for adjusting the width /

measuring the belt tension

(5) Direction of PCB transport

Loosen the cam shaft on the idler pulley

and set the belt tension.

1 - 13

Student Guide SIPLACE HF/HF3

Edition 09/2005 9 Modular conveyor

9.2.1.1 Settings for the belt tension

Please Note:

In the modular transport, 3 different lengths of toothed belts are used. The different belt tensions

between the conveyor tracks results from the different arrangement of the hexagon shafts and id-

ler pulleys.

Belt tension for the width adjustment: 30 Hz +/- -2 Hz

Belt tension for track 1 (single and dual conveyors)

Input conveyor: 102 Hz +/- 10 Hz

Placement area 1: 66 Hz +/- 7 Hz

Intermediate conveyor: 94 Hz +/- 9 Hz

Placement area 2: 66 Hz +/- 7 Hz

Output conveyor: 102 Hz +/- 10 Hz

Belt tension for track 2 (dual conveyor)

Input conveyor 144 Hz +/- 14 Hz

Placement area 1: 71 Hz +/- 7 Hz

Intermediate conveyor 94 Hz +/- 9 Hz

Placement area 2: 71 Hz +/- 7 Hz

Output conveyor 144 Hz +/- 14 Hz