SG_FSE_SiplaceHF_HF3_00193901-05_eng.pdf - 第562页

1 - 88 S tudent Guide SIPLACE HF/HF3 1 1 MTC 2 Edition 09/2005 88 Download parameter set: 11 ➠ Select "File" --> "DOWNL OAD" --> "Save (EEPROM)" ➠ Switch OFF and ON the MTC and st art …

1 - 87

Student Guide SIPLACE HF/HF3

Edition 09/2005 11 MTC 2

Upload Parameter set: (Storage the parameter set) 11

➠ Choose "File" --> "UPLOAD" --> "BASIC DEVICE COMPLETE"

➠ Save the parameter set under a name which make sense, for example feed axis tower 1 and

additionally the serial number of the MTC2.

Fig. 11.4 - 8 Upload parameter set

1 - 88

Student Guide SIPLACE HF/HF3

11 MTC 2 Edition 09/2005

Download parameter set: 11

➠ Select "File" --> "DOWNLOAD" --> "Save (EEPROM)"

➠ Switch OFF and ON the MTC and start the reference run.

Note:

Before you start the download, the master drive should be reset to factory defaults (see 11.4.3)

Note:

The axis concerned must not be subject to position control!

TIP

There are two ways of deactivating position control:

- Open the door of the MTC.

- Switch the MTC on and do not perform a reference run.

Fig. 11.4 - 9 Download Parametersatz

Note:

Save om EEPROM!

Note:

When errors are counted in the field E:(Error), abort the download immediately and try again.

1 - 89

Student Guide SIPLACE HF/HF3

Edition 09/2005 11 MTC 2

11.4.6 Error messages issued via the station

Faults and Alarms Master drive

NOTE

Alarm messages will begin with „Axxx“. An alarm cannot be acknowledged.

It is automatically deleted once the cause has been eliminated.

A140, A141 Axis blocked, Check the mechanical system.

NOTE

Fatal errors will begin with „FFxx“. Fatal errors are serious hardware or software errors which no

longer permit normal operation of the Master drives. They only appear on the PMU in the form

"FF<No>". The software is re-booted by actuating any key on the PMU.

FF01 Time overflow

FF04 A fault has occurred during the test of the RAM.

FF05 A fault has occurred during the test of the EPROM.

FF13 A versions conflict between the firmware and the hardware has

occurred.

NOTE

Fault messages will begin „Fxxx“. If a fault message is not reset before the electronic supply volt-

age is switched off, then the fault message will be present again when the electronic supply is

switched on again.

F002 The monitoring time has expired.The DC link voltage has not

reached the setpoint(3s).

F006 DC link overvoltage.

F008 DC link undervoltage. (lower limit value(76%)of the DC link volt-

age)

F011 Overcurrent

F015 Axis blocked during the reference run

F020 Monitoring Motor temperature occurred.

F021 Motor blocked, (I2t-Monitoring for the motor)

F023 Excess temperature Master drives.

F035 Axis in the limit switch.

F041 A fault has occurred during the storage of values in the EEPROM.

F051 Fault Resolver or connecting fault

F082 Telegram fault.

F085 A fault has occurred during initialization of the Controller board

Master drives.