00194614-08 Trainingsdoku. SG X-Serie_X4i SW70x (AL2)_EN.pdf - 第264页
C&P20A Pneumatic Plan for Nozzle Changer Room for Your Sketches a nd Notes Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 264
C&P20A
Room for Your Sketches and Notes Pneumatic Plan for Nozzle Changer
263 Student Guide SIPLACE X-Serie and X4I SW70x (AL2)
{Commented by , XXX: Check!!}
Room for You r Sketches and Notes
7.7 Room for Your Sketches and Notes
C&P20A
Pneumatic Plan for Nozzle Changer Room for Your Sketches and Notes
Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 264
Collect, Pick and Place Head (CPP)
Important Information Application
265 Student Guide SIPLACE X-Serie and X4I SW70x (AL2)
Collect, Pick and Place He ad (CPP)
8 Collect, Pick and Place Head (CPP)
Importan t Inform ation
8.1 Important Information
Overview
8.2 Overview
Applicat ion
8.2.1 Application
The CPP head can be used in the following machines:
▪ X series (X2, X3, X4, X4I)
▪ SX1 - machine with one gantry
▪ SX2 - machine with two gantries
▪ SX4 - machine with four gantries
CAUTION
Head exchange X series
When replacing the TwinHead with a CPP head with MTC2 in this placement area, you need
to fit a bumper extension, to limit the Y travel range. After switching the machine back on, you
then need to redetermine the machine zero point and the travel ranges.
When you use a TwinHead again, you need to remove the bumper extension.
CAUTION
Risk of head crash!
When installing a CPP head with a stationary camera, this needs to be fitted in the top position
otherwise there is a risk of a head crash!
Overview of CPP head
CPP placement head without camera SST29
[03070108-xx]
CPP placement head with camera SST29 [03053528-xx]
Legend
1. Intermediate distributor 1 and 2
2. Star motor (integrated into the head housing)
3. DP axis (as direct drive)
4. Pressure control valve
5. Component camera (behind the intermediate
distributor, standard: SST29)
6. Single core solution (SCS) – DP drive control
7. Holding circuit supply, integrated venturi nozzles and
valve assembly (valve terminal)
8. Z axis with return cylinder
9. Component sensor in the pick and place position