00194614-08 Trainingsdoku. SG X-Serie_X4i SW70x (AL2)_EN.pdf - 第468页
MTC2 SITEST Calibration Flow Charts MTC2 Calibration and Settings Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 468 Feed axi s 13.3.2.2 Feed axis Notes for c alibration the zeropoint c orrection and transf er pos iti…
MTC2
MTC2 Calibration and Settings SITEST Calibration Flow Charts
467 Student Guide SIPLACE X-Serie and X4I SW70x (AL2)
SITEST Cali bration Flow C harts
13.3.2 SITEST Calibration Flow Charts
Lifting axis
13.3.2.1 Lifting axis
Overview "Calibration Lifting axes"
MTC2
SITEST Calibration Flow Charts MTC2 Calibration and Settings
Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 468
Feed axis
13.3.2.2 Feed axis
Notes for calibration the zeropoint correction and transfer position into the machine.
1a. Calib ration of ze ro point correction:
1a. Calibration of zero point correction:
► Select SITEST --> MTC --> Settings
► Select Teach zero point.
► Check the position of the driver with the ENGAGE.
In case the driver did not engaged successfully you must determine the middle of the notch of the waffel
pack tray.
The accurate adjustment is described below:
► If the feed axis is positioned so that the driver is unable to connect, move the feed axis into an
approximately correct position, in which the driver is able to engage. Now determine the minimum
and maximum position in which the driver can engage.
► Once the driver has engaged, gently tap the feed axis into the minimum position, until the driver is
just unable to engage (see diagram).
► Make a note of the position value shown.
Minimum position
► Now gently tap the feed axis into the maximum position, until the driver is just unable to engage (see
diagram).
MTC2
MTC2 Calibration and Settings SITEST Calibration Flow Charts
469 Student Guide SIPLACE X-Serie and X4I SW70x (AL2)
Maximum position
► Now calculate the center of the WT gap, so that the driver will always engage reliably.
e.g. |-257| + 596 = 853 divided by 2 = 426 µm
426 + the maximum position or minimum position or maximum position - 426 = approx. 169 µm
Correct position for the feed axis
► Check the driver position. The driver now should be correctly in the middle position of the notch of
the WTC.
► Click on Accept.
► Check the position of the driver for the other cassettes.