00194614-08 Trainingsdoku. SG X-Serie_X4i SW70x (AL2)_EN.pdf - 第421页

Head Modularity Head Modularity CPP/C&P to Twin Head Calibration 421 Student Guide SIPLACE X-Serie and X4I SW70x (AL2) Head Modularity CPP/C&P to Twin Head 12.4 Head Modularity CPP/C&P to Twin Head Procedure …

Head Modularity

Calibration Head Modularity

Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 420

Autoconfiguration

12.3.3.1 Autoconfiguration

► After the zero point correction has been transferred, check the nozzle configuration at the placement

head and in the nozzle changer.

► Perform a complete calibration of the placement head.

► If the head has been precalibrated, brief calibration can be performed with the menu Fast Head

Exchange !

After the head exchange or replacing other hardware

components, an automatic configuration will be

performed when machines with software 702 or higher

are restarted.

This means that manual configuration settings should no

longer be necessary.

► This menu allows you to check the configuration and

change it if required.

This is where the axis data (Z and star axes) can be

written from the head EPROM to the machine data. You

can also write the Z and star axis data from the machine

data to the head EPROM.

► In the Zero correction data (1) select the line

Zero point correction (2).

► ;Move the value out of the head EPROM and into the

machine data (3).

► Select Write head & machine data (4).

► The arrow button (5) takes you back one menu level.

Head Modularity

Head Modularity CPP/C&P to Twin Head Calibration

421 Student Guide SIPLACE X-Serie and X4I SW70x (AL2)

Head Modularity CPP/C&P to Twin Head

12.4 Head Modularity CPP/C&P to Twin Head

Procedure for head exchange CPP/C&P to TwinHead

Head Modularity

Calibration Head Modularity Twin Head to CPP/C&P

Student Guide SIPLACE X-Serie and X4I SW70x (AL2) 422

Head Mo dularity T win Head to CPP/C &P

12.5 Head Modularity Twin Head to CPP/C&P

Procedure for head exchange TwinHead to CPP/C&P

Head Modular ity C&P20A to CPP Head

12.6 Head Modularity C&P20A to CPP Head

Preparation:

► Place the nozzles from all heads, even those which were not exchanged, in the nozzle changer.

► Back up the machine data with Save machine data.

► Switch off the machine.

NOTICE

After conversion, a new autoconfiguration file will be compiled when the machine is switched

back on.