2OM-1064-002.pdf - 第13页
Section 2 Pattern Program 9910-001 2-1 Tg0247-PM-PM
0004-001 1-4 Tg0247-PM-PM
Section 2
Pattern Program
9910-001 2-1 Tg0247-PM-PM
1. Scope of Pattern Program
The pattern program data is indispensable because the automatic operation is
controlled by the data when performed with this machine.
Note: Pattern program data can be edited on machine side. However, it is
recommended that pattern program data be edited, using a program-
ming device (option).
Pattern program data is composed of the following.
Operation Data
The operation data takes a role to summarize the pattern program data and is
composed of items such as “P.C.B. Size”, “Placement Mode”, “Designation of
Overall P.E.C. Recognition Mode”.
Refer to “2.3 OPERATION DATA Display of Section 2” for details.
Set-Up Data
This data is used to determine whether or not the conveyor width automatic
set-up operation should be performed sequentially with the [MOVE] button
(performed when the [MOVE] button is pressed) during program change op-
eration.
To implement the automatic set-up operation, set “ON” in the “CONVEYOR
WIDTH” data box at the “SET-UP DATA” display.
Refer to “2.4 SET-UP DATA Display of Section 2” for details.
Component Data
This data is used to designate which feeder position of the machine in order to
set various components to be placed on the P.C.B.
Feeder slot Nos. are allocated to some feeder blocks - “F101 to F139” belong
to the feeder section on Beam A side, “F201 to F239” to the feeder section on
Beam B side, “F301 to F599” (Option) to Tray L, and “F601 to F899” (Option)
to Tray R. A certain type (component ID) of components can be designated to
each feeder block.
Refer to “2.5 COMPONENT DATA Display of Section 2” for details.
Placement Data
This data is used to set parameters which select components (FDR Nos.) and
determine coordinates (X and Y) on the P.C.B. and directions (Z) of compo-
nent placement.
Data is created by allocating one step to one piece of component to be placed.
Refer to “2.6 Placement Data of Section 2” for details.
Steps for Data Creation
Be sure to follow the steps below to create various data.
(1) Create operation data.
(2) Create set-up data.
(3) Create component data.
(4) Create placement data.
1. Scope of Pattern Program
9910-001 2-2 Tg0247-PM-PM