2OM-1064-002.pdf - 第133页
*1 0004-002 2-121 Tg0247-PM-PM 4. P A TTERN PROGRAM Display 4.6.4 Special Operation (Step Copy) for Placement Data (1) When the [STEP COPY] key is pressed at the “PLACEMENT DA T A (P) U01” display (Fig. 2.1 1 1-1 or Fig.…
*1
0004-002 2-120 Tg0247-PM-PM
Example: Jumping to the P0100 Step
(1) Open the “PLACEMENT DATA (P) U01” display (Fig. 2.112-1).
(2) Enter “0100”, using the ten-key pad and press the [SET] key. The line
cursor jumps to the P0100 step as shown in Fig. 2.112-2.
4. PATTERN PROGRAM Display
Fig. 2.112-2
Ref.: When the [PROGRAM CHECK] key *1 is pressed, the current pattern
program is checked.
*1
0004-002 2-121 Tg0247-PM-PM
4. PATTERN PROGRAM Display
4.6.4 Special Operation (Step Copy) for Placement Data
(1) When the [STEP COPY] key is pressed at the “PLACEMENT DATA (P)
U01” display (Fig. 2.111-1 or Fig. 2.111-2), the following display ap-
pears on the screen.
Pressing the [STEP COPY] key at the “PLACEMENT DATA (O)
U01” or the “PLACEMENT DATA (V) U01” display follows the
similar hierarchical sequence.
Fig. 2.113-1
(2) Move the line cursor to the step No. of the data to be copied.
(3) Enter the destination step No., using the ten-key pad and press the [SET]
key.
The parameters of the step No. (selected by the line cursor) are copied to
the text line of the destination step No.
The destination step No. appears under step No. 0000 and the subsequent
Nos. follow.
0004-002 2-122 Tg0247-PM-PM
4. PATTERN PROGRAM Display
Example: Copying the data in Step No. 0013 to set it as the pa-
rameters in Step No. 0100
(1) Open the “PLACEMENT DATA (P) U01” display (Fig. 2.113-1).
Move the line cursor to the P0013 step.
(2) Enter “0100”, using the ten-key pad and press the [SET] key.
The data is copied and appears as the parameters in Step No. 0100 under
Step No. 0000 as shown in Fig. 2.113-2.
Fig. 2.113-2
Ref.: When the [PROGRAM CHECK] key *1 is pressed, the current pattern
program is checked.
*1