2OM-1064-002.pdf - 第132页
*1 0004-002 2-120 Tg0247-PM-PM Example: Jumping to the P0100 Step (1) Open the “PLACEMENT DA T A (P) U01” display (Fig. 2.1 12-1). (2) Enter “0100”, using the ten-key pad and press the [SET] key . The line cursor jumps t…
*1
0004-002 2-119 Tg0247-PM-PM
4.6.1 Special Operation (Step Delete) for Placement Data
(1) Move the line cursor to the step No. of the data to be deleted.
(2) Press the [STEP DELETE] key.
The data of the step No. at the line cursor is deleted.
The line at the line cursor position is deleted and the subsequent lines
scroll up.
4.6.2 Special Operation (Step Insert) for Placement Data
(1) Move the line cursor to the step No. of the data to be inserted.
(2) Press the [STEP INSERT] key.
A new step line (placement data) is inserted below the step No. at the
cursor position.
4.6.3 Special Operation (Step Jump) for Placement Data
(1) When the [STEP JUMP] key is pressed at the “PLACEMENT DATA (P)
U01” display (Fig. 2.111-1 or Fig. 2.111-2), the following display ap-
pears on the screen.
Pressing the [STEP JUMP] key at the “PLACEMENT DATA (O)
U01” or the “PLACEMENT DATA (V) U01” display follows the
similar hierarchical sequence.
4. PATTERN PROGRAM Display
Fig. 2.112-1
(2) Enter the step No. to jump to, using the ten-key pad and press the [SET]
key.
*1
0004-002 2-120 Tg0247-PM-PM
Example: Jumping to the P0100 Step
(1) Open the “PLACEMENT DATA (P) U01” display (Fig. 2.112-1).
(2) Enter “0100”, using the ten-key pad and press the [SET] key. The line
cursor jumps to the P0100 step as shown in Fig. 2.112-2.
4. PATTERN PROGRAM Display
Fig. 2.112-2
Ref.: When the [PROGRAM CHECK] key *1 is pressed, the current pattern
program is checked.
*1
0004-002 2-121 Tg0247-PM-PM
4. PATTERN PROGRAM Display
4.6.4 Special Operation (Step Copy) for Placement Data
(1) When the [STEP COPY] key is pressed at the “PLACEMENT DATA (P)
U01” display (Fig. 2.111-1 or Fig. 2.111-2), the following display ap-
pears on the screen.
Pressing the [STEP COPY] key at the “PLACEMENT DATA (O)
U01” or the “PLACEMENT DATA (V) U01” display follows the
similar hierarchical sequence.
Fig. 2.113-1
(2) Move the line cursor to the step No. of the data to be copied.
(3) Enter the destination step No., using the ten-key pad and press the [SET]
key.
The parameters of the step No. (selected by the line cursor) are copied to
the text line of the destination step No.
The destination step No. appears under step No. 0000 and the subsequent
Nos. follow.