YSM20R_YSM20WR_Ope_E.pdf - 第132页

2-29 2 Basic operation 3.5 Retr y T he [Retry] screen displays the history or the past 100 errors. If the machine has to retry the oper ation due to a recognition error or a pickup error , check this screen. Monitor: Fid…

100%1 / 229
2-28
2
Basic operation
3.4 Alignment
This screen shows a list of the mounting position correction amount following up on component recognition
results during the automatic operation, error numbers and the like.
Monitor: Alignment
24215-KMK-00
• Table Select
Select a head unit.
• Head No.
The head number indicates the component recognition results of one sequence for each head that starts with the current
pickup operation.
Note that the indication reflects the results after the camera finishes recognizing the image.
• Parts No.
Shows the number of the component picked up by the head and recognized with the camera.
• Feeder Set No.
Shows the feeder set number of the component picked up by the head and recognized with the camera.
• X, Y, R
Displays the offset amount of each head calculated from the recognition results obtained during automatic operation. This
offset is the positional deviation from the center of the nozzle.
• Error No.
Shows an error number when the head fails to recognize a component.
2-29
2
Basic operation
3.5 Retry
The [Retry] screen displays the history or the past 100 errors.
If the machine has to retry the operation due to a recognition error or a pickup error, check this screen.
Monitor: Fiducial
24216-KMK-00
2-30
2
Basic operation
3.6 Fiducial
The Fiducial screen shows the results of recognizing fiducial marks such as “Board, Block”, “2 Point Local” and
“Point” and the correction result.
Monitor: Fiducial
24217-KMK-00
• Table Select
Select a head unit.
• Fiducial Type
Select the type of the fiducial mark such as "Board, Block", "2Point Local" or "Point".
• Align X, Y, R
Shows the differences between the fiducial mark recognition results and the input coordinate entered in the board data
with positive or negative values.
• Align Ratio
Shows the rate of expansion of the board, calculated by using the X, Y and R offset values.
• Result
Shows the recognition results as a "Pass" or "Unfinished ". The "Unfinished" message changes to "Pass" after the mark has
been recognized successfully.