YSM20R_YSM20WR_Ope_E.pdf - 第199页

3-11 3 Flow fr om starting up machine to production 2 Lift the main stopper . Lift the main stopper to place the board at the board mount ing position. Press the [Main Stopper] button on the “Unit” – “Conveyor” scree n t…

100%1 / 229
3-10
3
Flow from starting up machine to production
n
YSM20R Dual-stage type
1. Press [Mount Position] button in [Setup] screen.
2. The message "Move Conveyor Unit To Mounting Position" is displayed, and then press [Yes].
The conveyor unit moves to the mount position.
Moving to the mount position
Dual stage : [Setup] screen
[MountPosition] button
24308-KMK-00
TIP
Pressing [Mount Position] on the dual-stage type machine also makes the conveyor width changed to the width
specified in the board data.
3-11
3
Flow from starting up machine to production
2
Lift the main stopper.
Lift the main stopper to place the board at the board mounting position.
Press the [Main Stopper] button on the “Unit” – “Conveyor” screen to lift the main stopper.
If dual-stage type machine, press the [Main Stopper] buttons for both of stage 1 and stage 2.
Lifting the main stopper
Dual stage : [Unit] - [Conveyor] screen
[Main Stopper] button
24309-KMK-00
3
Move up the push-up plate.
1. Press [Push Up] button on [Unit] - [Conveyor] screen. Then "Conveyor Push Up" screen appears.
2. Press [OK] button after confirming the board thickness is correct. Then push-up plate moves up.
3. If dual-stage type machine, move up the push-up plates for both stage 1 and stage 2.
Move up the push-up plate.
Dual stage : [Unit] - [Conveyor] screen
Stage 1 [Push Up] button
Stage 2 [Push Up] button
24310-KMK-00
3-12
3
Flow from starting up machine to production
4
Lay out the push-up pins.
Hold the push-up pins on the push-up plate with magnets.
e
1. Press [EMERGENCY STOP] button and open the safety cover.
2. If the carriage type machine, remove the carriage to easily access to the conveyor.
3. Temporarily place the board on the conveyor so that the board edge is in touch with main stopper.
4. Confirm the board size (meaning the area where the push-up pins are placed), and then temporarily
remove the board.
5. Lay out the push-up pins on the push-up plate so that the whole board including its edge are held
evenly by the pins. Be careful not to touch the components if they are mounted on the back side of
the board already.
Temporarily placing the board
Dual stage : Stage 1
Main stopper
23303-KMK-00