YSM20R_YSM20WR_Ope_E.pdf - 第148页

2-45 2 Basic operation 8 Set the co ver tape in the take-up roller . Push the portion of the P/O lever assembly shown in the figure to make a clearance. Insert a certain amount of the cover tape into this clearance and r…

100%1 / 229
2-44
2
Basic operation
n
Handling tape guides of 12 mm, 16 mm and 24 mm
12 mm, 16 mm and 24 mm tape guides can be used without passing the cover tape into the notch
of the tape guide assembly. Same as the 32 mm or wider tape guide assembly, the "Edge
delamination" that does not require to pass the cover tape into the notch is also available.
Cover tape insertion slot
Edge delamination of 12 mm, 16 mm and 24 mm tape guides
Cover tape insertion slot
Notch
Cover tape
Tape guide assembly
23206-KMK-00
7
Clamp the tape guide assembly.
While confirming that the sprocket teeth bite into the carrier tape, hold down the tape guide assembly
with the tape guide front lever to set the component tape.
Clamping the tape guide assembly
Tape guide front lever
Sprocket teeth
Carrier tape
Cover tape
Tape guide assembly
23207-KMK-00
c
CAUTION
Pull on the cover tape while clamping the tape guide assembly, so that the cover tape does not droop inside the tape
guide assembly during clamping.
2-45
2
Basic operation
8
Set the cover tape in the take-up roller.
Push the portion of the P/O lever assembly shown in the figure to make a clearance. Insert a certain
amount of the cover tape into this clearance and release the winding roller lever to pinch the cover
tape.
Take-up roller
Setting the cover tape
Cover tape
P/O lever ASSY
Tape guide assembly
23208-KMK-00
c
CAUTION
Check that the cover tape has not become twisted between the take-up roller and the tape guide assembly.
9
Reel the cover tape to take up the slack.
Pull the cover tape lightly in the direction of the arrow and the slack will be taken up automatically.
Taking up the slack of the cover tape
Cover tape
23209-KMK-00
c
CAUTION
• Using your hand, make sure the cover tape winds up straight.
• Reel the cover tape until the device takes up all slacks on the tap tape.
• During this task be careful not to cut your fingers while winding the cover tape.
2-46
2
Basic operation
0
Align the first component with the standby position.
If pressing the [FEED] button and the [BACK] button on the feeder, the tape can be transferred or
returned with the pitch setting corresponding to the feeder type.
1. Press the [FEED] button and transfer the tape to locate the first component on the temporary pickup
position (marking (white)).
2. After pressing the component pitch and the [BACK] button once to return the component, press the
[FEED] button once and align the first component with the standby position.
Operation buttons and adjusting component position
[FUNC] button
[BACK] button
[FEED] button
Press the [FEED] button to feed the
component to the pickup position.
Press the component pitch and the [BACK] button
once to return the component. Then press the [FEED]
button once and align the first component with the
standby position.
Pickup
position
Marking
First
component
Standby
position
First
component
(Standby
position)
23210-KMK-00
c
CAUTION
Make sure to align the standby position by the [FEED] button. Press the [BACK] button more than twice to return the
component. Then press the [FEED] button to align the component with the standby position. If aligning the standby
position by the [BACK] button, the pickup position offset of the fist component will occur.