YSM20R_YSM20WR_Ope_E.pdf - 第166页
2-63 2 Basic operation 2 Cut the used co ver tape. If the cover tape still remains, use the edge cutter installed behind the tail cove r to cut off the used cover tape. Cutting the used cover tape Cover tape to be cut Ed…
2-62
2
Basic operation
4.1.5 Disposing of used cover tape and carrier tape
As a daily routine, dispose of the used cover tape and carrier tape from time to time.
n
Disposing of used cover tape
n
NOTE
Especially when the components are supplied continuously with the tape splicing, the used cover tape accumulates
too much and pushes the tail cover causing to open it automatically as shown below. (the cover tape with about 2
reels of 8 mm tapes can be stored in a feeder)
Tape feeder with its tail cover automatically opened
Pushed out top tapeTail cover
23225-KMK-00
1
Check the used cover tape.
Open the tail cover to see whether there is used cover tape.
Check the cover tape in the feeder.
Checking the used cover tape
Tail cover
23226-KMK-00
2-63
2
Basic operation
2
Cut the used cover tape.
If the cover tape still remains, use the edge cutter installed behind the tail cover to cut off the used
cover tape.
Cutting the used cover tape
Cover tape to be cut
Edge cutter
23227-KMK-00
3
Close the tail cover.
Note that the tail cover has a magnet.
Closing the tail cover
Tail cover
Magnet
23228-KMK-00
2-64
2
Basic operation
n
Disposing of used carrier tape
The used cut-up pieces of carrier tape are collected in the empty tape dust box as the production goes on.
Dispose of the carrier tape from time to time.
Disposing of the carrier tape
Cut-off carrier tape
Empty tape dust box
23229-KMK-00