EUKYX-199-3100_G5S2_Instruction_Vol3_E.pdf - 第190页

EUKYX 2-42 199-3100 2.6 Nozzle 2.6 . 7 Pre ss -Fi t W or k Pressi ng the [Pre ss-Fit W ork] t ab on the "Nozz le" wi ndow displ ays the fo l lowi ng window . [1] [2] Graphic Development F3B54A [1] N o z z l e I…

100%1 / 230
EUKYX
2-41199-3100
2.6 Nozzle
2.6.5 LS Detection
Pressing the [LS Detection] tab on the "Nozzle" window displays the following window.
[1] [2]
Graphic
Development
F3B52A
[1] Nozzle
In this section, each nozzle No. is displayed.
[2] Head 1 / Head 2
Z [Ang]
As these parameters are for dummy PCB, they are not used currently.
2.6.6 Nozzle Axis
Pressing the [Nozzle Axis] tab on the “Nozzle” window displays the following window.
[1] [2]
Graphic
Development
F3B53A
[1] Nozzle
In this section, each nozzle No. is displayed.
[2] Head 1 / Head 2
X (Horizontal) / Y (Vertical) [mm] / Z [Ang]
Displayed is the offset data for nozzle replacement.
The displayed values indicate the offsets for the lowest levels of the special nozzles on the heads.
The lowest level of each nozzle is measured by the component recognition camera and the
difference between the actual and recognized levels is compensated for.
EUKYX
2-42199-3100
2.6 Nozzle
2.6.7 Press-Fit Work
Pressing the [Press-Fit Work] tab on the "Nozzle" window displays the following window.
[1]
[2]
Graphic
Development
F3B54A
[1] Nozzle
In this section, each nozzle No. is displayed.
[2] Head 1 and Head 2
Press Fit Level [mm]
The correction is performed when the nozzle attachment position is deviated due to the
component change in these text boxes. Positive value reduces the operation range and
negative value increases the operation range.
Load Control [%]
It is the set load offset data for load limit.
EUKYX
2-43199-3100
2.6 Nozzle
2.6.8 Noz Sel Axis Pos
Pressing the [Noz Sel Axis Pos] tab on the "Nozzle" window displays the following window.
[2][1]
Graphic
Development
F3B55A
[1] Nozzle
Each Nozzle No. is displayed in these boxes.
[2] Head1 / Head2
Z [Ang]
These offset parameters are used to correct the position relation between the nozzle selection axis
and the nozzle.