PathMaster-REV-L-4.5-1.pdf - 第37页

Machine Operati on Manual Revision L / February 2020 Page 37 of 200 M achine Parameters You must setu p the Ma chine Para meters t he fi rst time yo u use PathM aster ® . The Machine Paramete r window is u sed to set sof…

100%1 / 200
Machine Operation Manual
Revision L /
February 2020
Page 36 of 200
Figure 23: Select Project Window
4. Select “OK”.
Project Selection
You must select the correct project before you start to program. You can open an existing
project or create a new project. The Select Project window is shown at startup, when
PathMaster® changes the current machine setting, or if you open a different project.
1. Select the correct choice from the Select Project window.
2. Select the “OK” button.
3. Highlight the correct project.
4. Select the “OK” button to open the project.
Figure 24: Select a Project
5. Select the “Cancel” button to exit and make no changes.
Machine Operation Manual
Revision L /
February 2020
Page 37 of 200
Machine Parameters
You must setup the Machine Parameters the first time you use PathMaster®. The Machine
Parameter window is used to set software and hardware properties. The settings in the
Machine Parameter window apply only to the current machine profile. The current machine
profile is shown in the Upper Status Bar of the main PathMaster® window.
1. Select
Setup->Machine Parameters
from the Main menu to open the Machine
Parameters window.
Figure 25: Setup Machine Parameters
NOTE: If you attempt to make changes that require a MAIN program change, a window will
be shown to confirm the changes.
Figure 26: MAIN Program Change Conformation
2. To exit the Machine Parameters window, select “Save & Close” to save changes and
exit or “
Cancel” to exit and not save changes. The changes are not applied until you
select “
Save & Close”.
Machine Operation Manual
Revision L /
February 2020
Page 38 of 200
Dispensing Parameters
The dispensing parameters are the default parameters for all coordinated path motion.
These parameters can be modified in each programming function for each path segment.
These settings are found in the Machine Parameters window.
Figure 27: Dispensing Parameters
1. Select
Setup->Machine Parameters
from the Main menu to open the Machine
Parameters window.
2. Set the Path Acceleration and the Path Deceleration speed. This will be the default
acceleration and deceleration for all coordinated motion.