2OM-1075-002.pdf - 第23页

5. Conditions of P .C.B. before Placement Unit: mm Note: The dimensions are for design reference. Leave some room for the actual setting. 0206-003 1-6 AHB01ESPP 2. Specifications

P.C.B. Clamping: Mechanical Clamping

Note: The center of the

mark is the reference point.

The reference point and plane differ depending on the contents

of the specifications.

There is no change in the distances between the reference

point and the P.C.B. stopper and between the reference plane

and the P.C.B. locating side clamp (Y pusher).

Consult our marketing department or sales agency for details.

Unit: mm

2. Specifications

0206-002 1-5 AHB01ESPP

5. Conditions of

P.C.B. before

Placement

Unit: mm

Note: The dimensions are for design reference. Leave some room for

the actual setting.

0206-003 1-6 AHB01ESPP

2. Specifications

6. Component

Placeable

Range

Unit: mm

Notes: (a) The above figure shows that the vacuum nozzles are not pro-

truding from the outer shapes of components.

Consult our marketing department or sales agency for de-

tails.

(b) Components cannot be placed in the shadowed areas.

the opening such as a hole.

(d) The center of the

mark is the reference point.

The reference point and plane differ depending on the con-

tents of the specifications. There is no change in the distance

between the reference point and the P.C.B. stopper.

Consult our marketing department or sales agency for de-

tails.

7. Placement Time Chip-Type Components: Approx. 0.6 sec/pc. (Highest Speed)

IC (SOP/QFP) : Approx. 0.6 sec/pc. (Highest Speed)

BGA/CSP/FC : Approx. 0.6 sec/pc. (Highest Speed)

Notes: (a) P.C.B. transition time is not included in the placement time

under optimum conditions.

(b) When the accuracy of component placement is "±0.04

mm", the placement time becomes "0.77 seconds per

component".

and requirements for component placement. Consult our

marketing department or sales agency for details.

2. Specifications

0206-002 1-7 AHB01ESPP