00195941-03-UM SiplaceCA-EN.pdf - 第33页
User Manual SIPLACE CA 2 Operational Safety Edition 08/2011 EN 2.1 Safety Instructions 33 2 Operational Safety 2.1 Safety Instructions DANGER There is a risk for personne l and equipment if the safe ty instructions are n…
1 Introduction User Manual SIPLACE CA
1.10 Abbreviations Edition 08/2011 EN
32
SR Control computer
SWS SIPLACE Wafer System
TH TwinHead
VS Vision system
WLAN Wireless Local Area Network
User Manual SIPLACE CA 2 Operational Safety
Edition 08/2011 EN 2.1 Safety Instructions
33
2 Operational Safety
2.1 Safety Instructions
DANGER
There is a risk for personnel and equipment if the safety instructions are not followed!
Please observe the safety instructions in the relevant User Manual when carrying out work on
the machine. 2
2.1.1 Conventions for the Use of Hazard Symbols
This User Manual contains notes that must be observed to guarantee your personal safety and to
avoid damage to equipment. These notes are highlighted by warning triangles and are indicated
as follows according to the level of risk:
DANGER
as used in this manual means that death, severe injury or considerable damage to equipment
will occur if the danger instructions are not followed. 2
WARNING
as used in this manual means that death, severe injury or considerable damage to equipment
may occur if the warning instructions are not followed. 2
CAUTION
as used in this manual means that slight injury or damage to equipment may occur if the caution
instructions are not followed. 2
2 Operational Safety User Manual SIPLACE CA
2.1 Safety Instructions Edition 08/2011 EN
34
NOTE
as used in this manual provides information on the product or indicates a part of the manual that
requires particular attention. 2
2.1.2 Qualified Personnel
Qualified or adequately trained personnel means that these people are familiar with the setting up,
operation and preventive maintenance of automatic placement systems and add-on devices and
are suitably qualified, e.g.
– have been trained, instructed or authorized to switch on and off, isolate, earth and identify
electrical circuits and system components in accordance with normal safety standards.
– have been trained or instructed in the upkeep and use of appropriate safety equipment in ac-
cordance with normal safety standards.
– have received first aid training.
2.1.3 Correct Usage
This product must only be used for the intended application described in the catalogues and tech-
nical descriptions, i.e. to place SMD components and bare dies from a wafer and only in combi-
nation with external devices and components recommended or approved by ASM Assembly
Systems GmbH & Co.KG. Use for a different or extended purpose is not prescribed.
ASM Assembly Systems GmbH & Co.accepts no liability for any damages that may result from
improper use and assumes no warranty for the error free and correct functioning of the compo-
nents.
Use as prescribed also includes compliance with all the instructions in the user manual.
For the product to operate correctly and reliably, it must have been transported, stored, erected
and assembled correctly and must be operated and maintained with care.