00195941-03-UM SiplaceCA-EN.pdf - 第363页

User Manual SIPLACE CA 5 Tasks on the Machine Edition 08/2011 EN 5.8 Changing Setups 363 5.8 Changing Setup s 5.8.1 Changing Setups at the Placement Machine 5.8.1.1 Printing Setup Changeover Instructions Before Setup Cha…

5 Tasks on the Machine User Manual SIPLACE CA

5.7 LCD and Status Display at the X-Feeder Module Edition 08/2011 EN

362

NOTE 5

Remove the component tape before a reference run.

Reference o

Red Position information is no

longer available for the com-

ponent tape drive

Remove the component tape (tape can be

moved out by pressing the arrow keys or

pulled out after raising the pickup window).

Then press the "FOIL" button to start the

reference run.

CAN BusError

(CAN Bus error)

Red CAN bus error Log off and on again, check the optical fiber

interface

ParNotSaved! Red Parameters were not saved Default parameters are loaded automatical-

ly, i.e. the most recent operator settings are

overwritten -> The settings (e.g. increment)

will have to be made again. Replace the

control board if this error occurs frequently.

ParWrongSave Red Wrong or incomplete param-

eters were saved

BootFlashErr

FlashDataErr

Red Can no longer write to boot

or application memory cor-

rectly

Replace the feeder module or control board

Text on the

LCD display

Status

display

Meaning Troubleshooting

User Manual SIPLACE CA 5 Tasks on the Machine

Edition 08/2011 EN 5.8 Changing Setups

363

5.8 Changing Setups

5.8.1 Changing Setups at the Placement Machine

5.8.1.1 Printing Setup Changeover Instructions Before Setup Changes

Before a change of setup, print out the conversion instructions on the printer for the SIPLACE Pro

computer as described in the "SIPLACE Pro" manual or in the online help.

5.8.1.2 What You Should Note when Changing the Feeder Modules

 Handle the feeder modules carefully when you insert them into or remove them from the com-

ponent feeder table. Do not hit the X feeder against the centering bar (see item 5 in fig. 5.5 -

3, page 353) of the changeover table.

 Vacuum the supporting surfaces of the feeder modules and clean the surface of the compo-

nent feeder table when necessary according to the instructions in the Preventive Mainte-

nance Manual.

 Remove loose components using a brush or a vacuum cleaner with a suitable nozzle.

CAUTION 5

Avoid removing components from the component table with your fingers. You may hurt your-

self with tiny splinters of metal.

5 Tasks on the Machine User Manual SIPLACE CA

5.8 Changing Setups Edition 08/2011 EN

364

5.8.2 Changing Setups at the SWS

 Check if the orientation of the wafer locking bar fits with the relevant wafer size (10,5" oder

10,8" bei 8" Wafern) (see fig. 3.7 - 19

, page168).

NOTE 5

During commissioning, the SWS is configured according to the required wafer size (8" or 12")

and thickness of the wafer frame. Adapting the SWS to other sizes and thicknesses is de-

scribed in the service manual.

 Adjust the feeder plate for the wafer magazine (8" or 12") and insert the new magazine. Make

sure the magazine has the correct configuration.

 Check the needle configuration at the die ejector (see section 5.2.5, page 338).

 Check, if the flip unit is equipped with the appropriate tools and nozzles (see section 5.2.6,

page 342).

 Load or compile the required product (see software guide).