00195941-03-UM SiplaceCA-EN.pdf - 第71页
User Manual SIPLACE CA 2 Operational Safety Edition 08/2011 EN 2.6 Safety Instructions for Operating the Placement Machine 71 2.6.4 Safety Instructions for Manually Moving the Z Axis at the T winHead CAUTION RISK OF CRUS…
2 Operational Safety User Manual SIPLACE CA
2.6 Safety Instructions for Operating the Placement Machine Edition 08/2011 EN
70
NOTE 2
The manual removal of tantalum capacitors which have not been picked up is described in sec-
tion 6.1.1.3, page 378.
2.6.3 Safety Instructions for Removing Nozzles from Collect&Place CA Heads
CAUTION
RISK OF INJURY TO FINGERS BY SHARP NOZZLES 2
Do not remove the nozzles in the pick/place position (item 2 and 4 in fig. 2.6 - 2).
The procedure for removing nozzles manually from the sleeve is as follows:
Step the sleeve, from which you want to remove the nozzle, to the removal position (item 1
and 3 in fig. 2.6 - 2
).
Remove the nozzle from the sleeve here.
2
Fig. 2.6 - 2 Position of the sleeve during a manual nozzle change
(1) Removal position for sleeves and nozzles, C&P12 CA
(2) Pickup and place position, C&P12 CA
(3) Removal position for sleeves and nozzles, C&P6 CA
(4) Pickup and place position, C&P6 CA
User Manual SIPLACE CA 2 Operational Safety
Edition 08/2011 EN 2.6 Safety Instructions for Operating the Placement Machine
71
2.6.4 Safety Instructions for Manually Moving the Z Axis at the TwinHead
CAUTION
RISK OF CRUSHING AT THE TWINHEAD 2
NEVER move the Z axis down with your hand at the buffer of the retract unit. The strong spring
force of the cylinder poses a risk of injury to your fingers, when the bumper springs back. This
also applies to the inside of the TwinHead, when the piston rod return to its starting position.
Fig. 2.6 - 3 Risk of crushing from the retract unit on the TwinHead
(1) Retract unit, compressed air cylinder
(2) Piston rod
(3) Bumper of the retract unit
(4) Crushing point for fingers
2 Operational Safety User Manual SIPLACE CA
2.6 Safety Instructions for Operating the Placement Machine Edition 08/2011 EN
72
2.6.5 Safety Instructions for the TwinHead Component Cameras during
a Placement Head Change
WARNING 2
During a placement head change from TwinHead to Collect&Place CA head, the component
cameras (stationary P&P, type 33, 55 x 45, and type 25, 16 x 16) for the TwinHead must be dis-
mantled, otherwise the Collect&Place CA head will collide with the camera housings.
2
Fig. 2.6 - 4 Safety Instructions for the Vision Modules during a Placement Head Change
25 FC camera, type 25
33 IC camera, type 33
33 and 25
25 and 33
25 or 33 33 or 25
33 or 25
25 or 33
25 or 33
G3
G3
G4
G4
G1
G2
G2
G1
G4
G3
G2
G1
25 or 33