00195941-03-UM SiplaceCA-EN.pdf - 第67页
User Manual SIPLACE CA 2 Operational Safety Edition 08/2011 EN 2.6 Safety Instructions for Operating the Placement Machine 67 2.5.2 T ransporting the SWS WA R N I N G RISK OF TIPPING 2 If the required specifications of t…
2 Operational Safety User Manual SIPLACE CA
2.5 Safety Instructions for Transportation Edition 08/2011 EN
66
2.5 Safety Instructions for Transportation
2.5.1 Transporting the Placement Machine
2
Use a fork-lift truck with the following specification to carry the machine:
Fork length: min. 1800 mm
Carrying power: min. 6000 kg
Clear width between forks: min. 350 mm 2
WARNING
RISK OF TIPPING 2
If the required specification cannot be applied to the fork-lift, there is a risk that the fork-lift will tip
over when carrying the placement machine.
Transportation of the machine is described in section 4.2, page 245.
User Manual SIPLACE CA 2 Operational Safety
Edition 08/2011 EN 2.6 Safety Instructions for Operating the Placement Machine
67
2.5.2 Transporting the SWS
WARNING
RISK OF TIPPING 2
If the required specifications of the fork-lift truck are not met, there is the risk of the SWS tipping
down from the fork-lift truck.
Transportation of the SWS is described in section 4.3, page 254.
An appropriate hand-lift with the following specifications is sufficient for transporting the SWS:
Carrying power 1000 kg at least
Fork length 1000 mm at least
Distance between the forks 300 at least, 520 mm at most (outer dimension) 2
NOTE 2
The necessary width of the fork lift presents a critical measure. You should absolutely make sure
that the hand-lift used meets the required specifications.
2.6 Safety Instructions for Operating the Placement
Machine
2.6.1 Safety Instructions for Closing the Protective Covers
To avoid any injuries when closing the protective covers on the machine, the operator must in-
struct all personnel to following the instructions below when operating the protective covers.
CAUTION
RISK OF CRUSHING HANDS
IF THE PROTECTIVE COVERS ARE NOT CLOSED CORRECTLY 2
2 Operational Safety User Manual SIPLACE CA
2.6 Safety Instructions for Operating the Placement Machine Edition 08/2011 EN
68
2
Fig. 2.6 - 1 Safety instructions for closing the protective covers
(1) Protective covers
(2) Handles
(3) Cover flaps above the PCB conveyor
(4) Warning strips
(5) SWS sliding door
Always hold the grab handles when opening or closing the protective covers.
When closing, do not reach into the gap between the cover or sliding door and the machine
housing.
This area is marked with a yellow and black warning strip (item 4 in fig. 2.6 - 1
, page 68).
When you close the cover, make sure that there is no second person in the swiveling range
of the cover.
When you close the covers, make sure that there is no-one else in the vicinity of the opposite
component trolley location.